ipatch

A place for collecting, gathering, and organizing notes for repairing & fixing microsoft surface pro 4 tablet/pc.

busted tablet #1

when testing the Schottky Diode with my meter i got 0.2V with the red probe on the left side of the diode and when the red probe was placed on the right side of the diode i got OL

i was able to remove the ITE chip this afternoon using hot air and board preheater. i had my hot air on the lowest setting with temp at 395 and the board preheater at 300

both surface tablets i have use the same logic board, ie. the X910540-007

juancsr

Run docker in macos without docker desktop

NOTE: I want disclaimer that this work is not complete mine. Most of the work here is comming from: https://dhwaneetbhatt.com/blog/run-docker-without-docker-desktop-on-macos

Run brew doctor and update to make sure everything is working and up to date

$ brew doctor
$ brew update

ChipCE

READ THIS FIRST

Adaptive bed mesh is merged into klipper master branch. You can use this feature without this custom macro. Official klipper adaptive bed mesh

Klipper mesh on print area only install guide

What this macro do

• This macro will dynamically changing the bed mesh area based on the size of the parts will be printed. The fw will only probe on the area that the part will be printed (plus mesh_area_offset value)

nikolak

# This file contains pin mappings and reasonable defaults for Prusa i3 MK3S
# printers. It will work with MK3 (non-S) by selecting the alternative filament
# sensor. References to common community mods are included as well.
#
# Note: The Einsy boards sold by Prusa have defective firmware on the
# usb-to-serial chip that makes the boards unusable with Klipper through USB.
# While flashing Klipper firmware must be done over USB, the board can be used
# via serial with no additional modification.
#
# To use this config, the firmware should be compiled for the AVR atmega2560.

ipatch

see comments.

ipatch

see attachments.

GrumpyChunks

Install Arch Linux on a mid-2015 MacBook Pro

This is based upon the LearnLinux.tv guide and this OdinsPlasmaRifle's gist

Assumptions

• /dev/sda1 will be our EFI partition
• /dev/sda2 will be an encryprted LVM ext4 filesystem

Installation Steps

ipatch

check/view attachments.

ipatch

see comment

ipatch

see attachments