Jamie jamiei

## edison_flashing_wifi
Do this at your own risk. I take no responsibility for any damage caused to your board.

My Intel Edison was shipped to me with old and buggy version of the Yocto Linux image. I purchased only the console block via Sparkfun (which has only one USB port connected to UART2 (serial connection) of the Edison therefore it's not connected to the actual USB on Edison) so I could not update to a new build the normal way.

I assume you have successfully connected to the Edison via the serial connection and can use the linux console on Edison.

1. Connect the Edison into a local WiFi network with `configure_edison --wifi`
2. Check that you can access to the Edison via SSH or with browser
	- if you can't, `vi /etc/systemd/system/basic.target.wants/network-gadget-init.service` and change the ip addresses to i.e 192.168.99.15
3. On Edison, `cd /`

## keybase.md

      
        
          
            
              
              1 file
            
          
          
            
              
              0 forks
            
          
          
            
              
              0 comments
            
          
          
            
              
              0 stars
            
          
        
        
          
              
          
          
            
                jamiei
                / keybase.md
            
            
              Created
              March 31, 2014 12:19
            
              
                keybase.md
              
          
        
      
        
  
      
    Keybase proof

I hereby claim:

I am jamiei on github.
I am jamiei (https://keybase.io/jamiei) on keybase.
I have a public key whose fingerprint is 308A 6CB8 9BEE 866F 30AD  C488 88AF F329 6841 A207

To claim this, I am signing this object:
	Do this at your own risk. I take no responsibility for any damage caused to your board.

	My Intel Edison was shipped to me with old and buggy version of the Yocto Linux image. I purchased only the console block via Sparkfun (which has only one USB port connected to UART2 (serial connection) of the Edison therefore it's not connected to the actual USB on Edison) so I could not update to a new build the normal way.

	I assume you have successfully connected to the Edison via the serial connection and can use the linux console on Edison.

	1. Connect the Edison into a local WiFi network with `configure_edison --wifi`
	2. Check that you can access to the Edison via SSH or with browser
	- if you can't, `vi /etc/systemd/system/basic.target.wants/network-gadget-init.service` and change the ip addresses to i.e 192.168.99.15
	3. On Edison, `cd /`