Kicad_pcb2gcode_script_for_Bundgard.sh

#!/bin/sh
# Generate front+back mill + cut gcode
#
# zwork is set at 0.0. Adjust z-coordinate after touch off (e.g. to 0.1/0.2 mm) to cut below surface.
# (0.0 is usually a bit shallow if touched of on contact)
#
# zcut is set at just -1.4 mm to avoid cutting into and damaging material below
#
# cutter-diameter is 3.0 mm for 3.0 mm fishtail tool. Can be changed to 1.6 mm for 30 degree V-bit.
#
# offset 0.125 (for isolation) can be tuned if pcb has room
pcb2gcode \
  --back *-B.Cu.gbr \
  --front *-F.Cu.gbr \
  --outline *-Edge.Cuts.gbr \
  --drill *-PTH.drl \
  --cut-feed=128 \
  --cut-infeed=200 \
  --cut-speed=2 \
  --cut-vertfeed=128 \
  --cutter-diameter=1.6 \
  --milldrill-diameter=1.0 \
  --dpi=1000 \
  --drill-feed=256 \
  --drill-speed=0 \
  --metric \
  --metricoutput \
  --mill-feed=500 \
  --mill-speed=2 \
  --mill-vertfeed=254 \
  --offset=0.125 \
  --zchange=10 \
  --zcut=-1.4 \
  --zdrill=-1.6 \
  --zero-start \
  --zsafe=3 \
  --zwork=0.0 \
  --extra-passes=1 \
  --drill-side back
  
# Strip tool changes from drill file
#
# notooldrill.ngc is the drill file without tool changes
grep -v "^T" drill.ngc > notooldrill.ngc

# Remove unsupported irrelevant g-code
grep -v "^G64" front.ngc > fix-front.ngc
grep -v "^G64" back.ngc > fix-back.ngc
grep -v "^G64" outline.ngc > fix-outline.ngc