Jim Bair jimbair

## USG WPA Supplicant Config for AT&T Fiber
*Important note to pay attention to*
You'll most likely use eth0 on a USG and eth2 or eth3 on a USG-Pro, edit the files accordingly. Do not run the supplicant on virtual interfaces (e.g. eth0.0), as it will not work.

*Pre-requisites*
Get certs, run the mfg_dat_decode tool. You should end up with 3 certs: CA_*.pem, Client_*.pem and PrivateKey_PKCS1_*.pem, as well as a a wpa_supplicant.conf file

In the archive generated by the tool, edit wpa_supplicant.conf to add the full path /config/auth/ to all 3 files:

network={
        ca_cert="/config/auth/CA_xxxxxx.pem"
	Important note to pay attention to
	You'll most likely use eth0 on a USG and eth2 or eth3 on a USG-Pro, edit the files accordingly. Do not run the supplicant on virtual interfaces (e.g. eth0.0), as it will not work.

	Pre-requisites
	Get certs, run the mfg_dat_decode tool. You should end up with 3 certs: CA_.pem, Client_.pem and PrivateKey_PKCS1_*.pem, as well as a a wpa_supplicant.conf file

	In the archive generated by the tool, edit wpa_supplicant.conf to add the full path /config/auth/ to all 3 files:

	network={
	ca_cert="/config/auth/CA_xxxxxx.pem"