Ender Gcode 3v2 Gcode

cura-end.gcode

G91 ;Relative positioning
G1 E-2 F2700 ;Retract a bit
G1 E-2 Z0.2 F2400 ;Retract and raise Z
G1 X5 Y5 F3000 ;Wipe out
G1 Z10 ;Raise Z more
G90 ;Absolute positionning

G1 X0 Y{machine_depth} ;Present print
M106 S0 ;Turn-off fan
M104 S0 ;Turn-off hotend
M140 S0 ;Turn-off bed

M84 X Y E ;Disable all steppers but Z

cura-start.gcode

; Ender 3 Custom Start G-code
G92 E0 ; Reset Extruder
G28 ; Home all axes
;G29 ; Probe Bed Mesh
M420 S1 ; Use mesh from EEPROM
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X0.1 Y20 Z0.3 F5000.0 ; Move to start position
G1 X0.1 Y200.0 Z0.3 F1500.0 E15 ; Draw the first line
G1 X0.4 Y200.0 Z0.3 F5000.0 ; Move to side a little
G1 X0.4 Y20 Z0.3 F1500.0 E30 ; Draw the second line
G92 E0 ; Reset Extruder
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X5 Y20 Z0.3 F5000.0 ; Move over to prevent blob squish

octoprint-before.gcode

; Remember to disable M112 under Settings -> Serial -> Behavior
M75 ;Start Print Job on Display
M117 <F>{{ event.name }} ;Send Filename to Display

octoprint-cancelled.gcode

; disable motors
M84

;disable all heaters
{% snippet 'disable_hotends' %}
{% snippet 'disable_bed' %}
;disable fan
M106 S0

M77 ;Stop Print Job on Display

octoprint-complete.gcode

M77 ;Stop Print Job on Display

octoprint-paused.gcode

M76 ;Pause Print Job on Display

octoprint-resumed.gcode

M75 ;Start Print Job on Display