jsonpoindexter

#include <NTPClient.h>
// change next line to use with another board/shield
#include <ESP8266WiFi.h>
//#include <WiFi.h> // for WiFi shield
//#include <WiFi101.h> // for WiFi 101 shield or MKR1000
#include <WiFiUdp.h>

const char *ssid     = "SDID";
const char *password = "PASSWORD";

jsonpoindexter

import processing.serial.*;

int numPorts=0;  // the number o
int maxPorts=24; // maximum number of serial ports

Serial[] mySerial = new Serial[maxPorts];     // each port's actual Serial port
boolean[] ledLayout = new boolean[maxPorts];   // layout of rows, true = even is left->right
int errorCount=0;

void setup() {

jsonpoindexter

import processing.serial.*;

int numPorts=0;  // the number o
int maxPorts=24; // maximum number of serial ports

Serial[] ledSerial = new Serial[maxPorts];     // each port's actual Serial port
boolean[] ledLayout = new boolean[maxPorts];   // layout of rows, true = even is left->right
int errorCount=0;

void setup() {

jsonpoindexter

#include <Adafruit_NeoPixel.h>
// Which pin on the Arduino is connected to the NeoPixels?
#define PIN            3
// How many NeoPixels are attached to the Arduino?
#define NUMPIXELS      128
Adafruit_NeoPixel strip = Adafruit_NeoPixel(NUMPIXELS , PIN, NEO_GRB + NEO_KHZ800);;


void setup(void) 
{

jsonpoindexter

void setup() {
  Serial.begin(115200);
}
byte Start = 0; // start byte is dec 0
byte Stop = 1; // stop byte is dec 1
int simDelay = 100; //simulated delay code would take
int postDelay = 100; //delay after the Stop byte gets sent in order to give Processing time to be ready for next Start signal
void loop() {
  Serial.write(Start);
  delay(simDelay);

jsonpoindexter

#define WAIT_FOR_KEYBOARD 1 // Use keyboard to pause/resume program.
/* Debug parameters: */
#define PRINT_LOOP_TIME 1

////////LED IMPORTS////////
#include "LPD8806.h"
#include "SPI.h"

/* LED parameters: */
// Number of RGB LEDs in strand: