Linux Web Server Kernel Tuning

sysctl.conf

# Configuration file for runtime kernel parameters.
# See sysctl.conf(5) for more information.

# See also http://www.nateware.com/linux-network-tuning-for-2013.html for
# an explanation about some of these parameters, and instructions for
# a few other tweaks outside this file.
#
# See also: https://gist.github.com/kgriffs/4027835
#
# Assumes a beefy machine with lots of network bandwidth

# Protection from SYN flood attack.
net.ipv4.tcp_syncookies = 1

# See evil packets in your logs.
net.ipv4.conf.all.log_martians = 1

# Enable source validation by reversed path, as specified in RFC1812
net.ipv4.conf.all.rp_filter = 1

# Ignore all ICMP ECHO and TIMESTAMP requests sent to it via broadcast/multicast
net.ipv4.icmp_echo_ignore_broadcasts = 1
net.ipv4.icmp_ignore_bogus_error_responses = 1

# Discourage Linux from swapping idle server processes to disk (default = 60)
vm.swappiness = 1

# Be less aggressive about reclaiming cached directory and inode objects
# in order to improve filesystem performance.
vm.vfs_cache_pressure = 50

# Tweak how the flow of kernel messages is throttled.
#kernel.printk_ratelimit_burst = 10
#kernel.printk_ratelimit = 5

# --------------------------------------------------------------------
# The following allow the server to handle lots of connection requests
# --------------------------------------------------------------------

# Increase number of incoming connections that can queue up
# before dropping
net.core.somaxconn = 5000

# Handle SYN floods and large numbers of valid HTTPS connections
net.ipv4.tcp_max_syn_backlog = 3000

# Increase the length of the network device input queue
net.core.netdev_max_backlog = 5000

# Increase system file descriptor limit so we will (probably)
# never run out under lots of concurrent requests.
# (Per-process limit is set in /etc/security/limits.conf)
fs.file-max = 184028

# Widen the port range used for outgoing connections
net.ipv4.ip_local_port_range = 10000 65000

# If your servers talk UDP, also up these limits
#net.ipv4.udp_rmem_min = 8192
#net.ipv4.udp_wmem_min = 8192

# --------------------------------------------------------------------
# The following help the server efficiently pipe large amounts of data
# --------------------------------------------------------------------

# Disable source routing and redirects
net.ipv4.conf.all.send_redirects = 0
net.ipv4.conf.all.accept_redirects = 0
net.ipv4.conf.all.accept_source_route = 0
net.ipv4.conf.all.secure_redirects = 0

# Disable packet forwarding.
net.ipv4.ip_forward = 0
net.ipv6.conf.all.forwarding = 0

# Disable TCP slow start on idle connections
net.ipv4.tcp_slow_start_after_idle = 0

# Increase Linux autotuning TCP buffer limits
# Set max to 16MB for 1GE and 32M (33554432) or 54M (56623104) for 10GE
# Don't set tcp_mem itself! Let the kernel scale it based on RAM.
net.core.rmem_max = 16777216
net.core.wmem_max = 16777216
net.core.rmem_default = 16777216
net.core.wmem_default = 16777216
net.core.optmem_max = 40960
net.ipv4.tcp_rmem = 4096 87380 16777216
net.ipv4.tcp_wmem = 4096 65536 16777216

# Enable BBR; requires Linux kernel version 4.9 or higher
net.core.default_qdisc=fq
net.ipv4.tcp_congestion_control=bbr

# --------------------------------------------------------------------
# The following allow the server to handle lots of connection churn
# --------------------------------------------------------------------

# Disconnect dead TCP connections after 1 minute
net.ipv4.tcp_keepalive_time = 60

# Wait a maximum of 5 * 2 = 10 seconds in the TIME_WAIT state after a FIN, to handle
# any remaining packets in the network.
# net.ipv4.netfilter.ip_conntrack_tcp_timeout_time_wait = 5
net.netfilter.nf_conntrack_tcp_timeout_time_wait = 5

# Allow a high number of timewait sockets
net.ipv4.tcp_max_tw_buckets = 40960

# Timeout broken connections faster (amount of time to wait for FIN)
net.ipv4.tcp_fin_timeout = 10

# Let the networking stack reuse TIME_WAIT connections when it thinks it's safe to do so
net.ipv4.tcp_tw_reuse = 1

# Determines the wait time between isAlive interval probes (reduce from 75 sec to 15)
net.ipv4.tcp_keepalive_intvl = 15

# Determines the number of probes before timing out (reduce from 9 sec to 5 sec)
net.ipv4.tcp_keepalive_probes = 5

# --------------------------------------------------------------------
# The following optimize connection setup
# --------------------------------------------------------------------

net.ipv4.tcp_fastopen = 3

@kgriffs I have a issues when I manually apply this by sysctl -p /etc/sysctl.d/zz-user.conf, all running docker swram services in this server cannot be accessed, and the server must be restarted to make it get back to work.