LightItUp.ino

    //
    // LightItUp
    //
    // A simple LED example using the Multiplo LED sensor.
    // Turns an LED on for one second,
    // then off for one second, and so on forever ... or until you
    // turn the Duinobot off.
    // 
    // We are using port S0 on the Duinobot board 
    //
    //  NOTES: 
    //      - Ports S0-S5 are analog input pins
    //      - S0 is identical to Arduino A0 and so on (S5=A5)
    //      - To use these ports as Digital pins add 14
    //

    #define S0 0+14

    void setup()                    // run once, when the sketch starts
    {
      pinMode(S0, OUTPUT);          // sets the digital pin as output
    }


    void loop()                     // run over and over again
    {
      digitalWrite(S0, HIGH);       // sets the LED on
      delay(1000);                  // waits for a second
      digitalWrite(S0, LOW);        // sets the LED off
      delay(1000);                  // waits for a second
    }