钟馗 liaozd

## README-setup-tunnel-as-systemd-service.md

      
              1 file
            
          
              75 forks
            
          
              42 comments
            
          
              371 stars
            
          
                drmalex07
                / README-setup-tunnel-as-systemd-service.md
            
            
              Last active
              May 4, 2024 15:04
            
              
                Setup a secure (SSH) tunnel as a systemd service. #systemd #ssh #ssh-tunnel #ssh-forward
              
          
    README

Create a template service file at /etc/systemd/system/secure-tunnel@.service. The template parameter will correspond to the name
of target host:
[Unit]
Description=Setup a secure tunnel to %I
After=network.target

  
## configure_docker0.sh
#!/bin/sh -e
#
# NOTE: Since Docker 1.10 (February 4, 2016), it has been possible to configure the
#   Docker daemon using a JSON config file.  On Linux, this file is normally located at
#   /etc/docker/daemon.json.  You should use this JSON config method if you are running
#   a version of Docker that is at least 1.10!
#   Here is an example configuration that sets the docker0 bridge IP to 192.168.254.1/24:
#   {
#     "bip": "192.168.254.1/24"
#   }

## 词性标记.md

      
              1 file
            
          
              133 forks
            
          
              15 comments
            
          
              378 stars
            
          
                luw2007
                / 词性标记.md
            
            
              Last active
              March 18, 2024 06:36
            
              
                词性标记： 包含 ICTPOS3.0词性标记集、ICTCLAS 汉语词性标注集、jieba 字典中出现的词性、simhash 中可以忽略的部分词性
              
          
    词的分类


实词：名词、动词、形容词、状态词、区别词、数词、量词、代词
虚词：副词、介词、连词、助词、拟声词、叹词。

ICTPOS3.0词性标记集

n 名词

nr 人名
	#!/bin/sh -e
	#
	# NOTE: Since Docker 1.10 (February 4, 2016), it has been possible to configure the
	# Docker daemon using a JSON config file. On Linux, this file is normally located at
	# /etc/docker/daemon.json. You should use this JSON config method if you are running
	# a version of Docker that is at least 1.10!
	# Here is an example configuration that sets the docker0 bridge IP to 192.168.254.1/24:
	# {
	# "bip": "192.168.254.1/24"
	# }