This is a klipper config for the Tronxy X5S using RAMPS/MKS Gen L as the controller.

tronxy_x5s_ramps_printer.cfg

[stepper_x]
step_pin: ar54
dir_pin: ar55
enable_pin: !ar38
step_distance: .0125
endstop_pin: ^!ar3
#endstop_pin: ^ar2
position_endstop: 0
position_max: 330
homing_speed: 50

[stepper_y]
step_pin: ar60
dir_pin: ar61
enable_pin: !ar56
step_distance: .0125
endstop_pin: ^!ar14
#endstop_pin: ^ar15
position_endstop: 0
position_max: 310
homing_speed: 50

[stepper_z]
step_pin: ar46
dir_pin: !ar48
enable_pin: !ar62
step_distance: .0025
endstop_pin: ^!ar18
#endstop_pin: ^ar19
position_endstop: 0.5
position_max: 400

[stepper_z1]
step_pin: ar36
dir_pin: !ar34
enable_pin: !ar30
step_distance: .0025

[extruder]
step_pin: ar26
dir_pin: ar28
enable_pin: !ar24
step_distance: .002
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: ar10
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog13
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250

#[extruder1]
#step_pin: ar36
#dir_pin: ar34
#enable_pin: !ar30
#heater_pin: ar9
#sensor_pin: analog15
#...

[heater_bed]
heater_pin: ar8
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog14
control: watermark
min_temp: 0
max_temp: 150

[verify_heater heater_bed]
check_gain_time: 600

[fan]
pin: ar9

[mcu]
serial: /dev/ttyUSB0
pin_map: arduino

[printer]
kinematics: corexy
max_velocity: 300
max_accel: 1000
max_z_velocity: 20
max_z_accel: 100

#[display]
#lcd_type: st7920
#cs_pin: 
#sclk_pin:
#sid_pin:

# "RepRapDiscount 2004 Smart Controller" type displays
#[display]
#lcd_type: hd44780
#rs_pin: ar16
#e_pin: ar17
#d4_pin: ar23
#d5_pin: ar25
#d6_pin: ar27
#d7_pin: ar29
#encoder_pins: ^ar31, ^ar33
#click_pin: ^!ar35

# "RepRapDiscount 128x64 Full Graphic Smart Controller" type displays
#[display]
#lcd_type: st7920
#cs_pin: ar16
#sclk_pin: ar23
#sid_pin: ar17
#encoder_pins: ^ar31, ^ar33
#click_pin: ^!ar35