This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
/** | |
* Marlin 3D Printer Firmware | |
* Copyright (c) 2019 MarlinFirmware [https://github.com/MarlinFirmware/Marlin] | |
* | |
* Based on Sprinter and grbl. | |
* Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm | |
* | |
* This program is free software: you can redistribute it and/or modify | |
* it under the terms of the GNU General Public License as published by | |
* the Free Software Foundation, either version 3 of the License, or |
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
/* | |
* Dump block 0 of a MIFARE RFID card using a RFID-RC522 reader | |
* Uses MFRC522 - Library to use ARDUINO RFID MODULE KIT 13.56 MHZ WITH TAGS SPI W AND R BY COOQROBOT. | |
----------------------------------------------------------------------------- | |
* Pin layout should be as follows: | |
* Signal Pin Pin Pin | |
* Arduino Uno Arduino Mega MFRC522 board | |
* ------------------------------------------------------------ | |
* Reset 9 5 RST | |
* SPI SS 10 53 SDA |