Skip to content

Instantly share code, notes, and snippets.

@miaoski

miaoski/sh4-nfsroot-boot-log

Created April 27, 2014 12:30
Show Gist options
  • Save miaoski/11344418 to your computer and use it in GitHub Desktop.
Save miaoski/11344418 to your computer and use it in GitHub Desktop.
Download ZIP
網樂通 nfsroot 開機 log
Raw
sh4-nfsroot-boot-log
Filename 'vmlinux.ub'.
Load address: 0x80000000
Loading: T #################################################################
#################################################################
#################################################################
#########
done
Bytes transferred = 2988970 (2d9baa hex)
PDK7105> setenv bootargs console=ttyAS0,115200 nfsroot=192.168.100.1:/srv/nfs/root root=/dev/nfs rw ip=192.168.100.5:192.168.100.1:192.168.100.1:255.255.255.0:sh4:eth0:off mem=256M
PDK7105> bootm 0x80000000
## Booting image at 80000000 ...
Image Name: Linux 2.6
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2988906 Bytes = 2.9 MiB
Load Address: 80800000
Entry Point: 80801000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
CMDLen=155
There is no "hwaddr" keywords!
Read MacAddr=24cf21b2a476
[iptv_kernel]:Starting kernel console=ttyAS0,115200 nfsroot=192.168.100.1:/srv/nfs/root root=/dev/nfs rw ip=192.168.100.5:192.168.100.1:192.168.100.1:255.255.255.0:sh4:eth0:off mehwaddr:24:cf:21:b2:a4:76 - 0x00000000 - 0 ...
Linux version 2.6.32.59_stm24_0211-PDK7105-32BITS-A18B (root@ubuntu) (gcc version 4.2.4 (snapshot) (STMicroelectronics/Linux Base 4.2.4-73)) #0 PREEMPT Sun Apr 27 16:55:37 CST 2014
Boot params:
... MOUNT_ROOT_RDONLY - 00000001
... RAMDISK_FLAGS - 00000000
... ORIG_ROOT_DEV - 00000200
... LOADER_TYPE - 00000000
... INITRD_START - 00000000
... INITRD_SIZE - 00000000
Booting machvec: pdk7105
Node 0: start_pfn = 0x40000, low = 0x50000
Zone PFN ranges:
Normal 0x00040000 -> 0x00050000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00040000 -> 0x00050000
STMicroelectronics PDK7105-SDK board initialisation
STx7105 version 3.x
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 65024
Kernel command line: console=ttyAS0,115200 nfsroot=192.168.100.1:/srv/nfs/root root=/dev/nfs rw ip=192.168.100.5:192.168.100.1:192.168.100.1:255.255.255.0:sh4:eth0:off mehwaddr:24:cf:21:b2:a4:76
PID hash table entries: 1024 (order: 0, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
PVR=04909200 CVR=60880000 PRR=00009e20
I-cache : n_ways=2 n_sets=512 way_incr=16384
I-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4
D-cache : n_ways=2 n_sets=512 way_incr=16384
D-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4
Memory: 246016k/262144k available (3849k kernel code, 1322k data, 148k init)
Hierarchical RCU implementation.
NR_IRQS:600
Failed to enable clk CLKA_REF, ignoring
Failed to enable clk CLKA_PLL0LS, ignoring
Console: colour dummy device 80x25
console [ttyAS0] enabled
sh_tmu: TMU0 used for clock events
sh_tmu: TMU0 used for periodic clock events
sh_tmu: TMU1 used as clock source
Calibrating delay loop... 448.51 BogoMIPS (lpj=897024)
Mount-cache hash table entries: 512
CPU: STx7105
NET: Registered protocol family 16
Configuring FLASH for boot-from-spi: boot_mode=2
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
cfg80211: Calling CRDA to update world regulatory domain
Switching to clocksource TMU1
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
NET: Registered protocol family 1
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
Slow work thread pool: Starting up
Slow work thread pool: Ready
NTFS driver 2.1.29 [Flags: R/O].
JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
ROMFS MTD (C) 2007 Red Hat, Inc.
msgmni has been set to 480
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
lirc_dev: IR Remote Control driver registered, major 61
lirc-stm: probe found data for platform device lirc-stm
lirc-stm: STM LIRC plugin using IRQ 125 in IR mode
lirc_dev: lirc_register_driver: sample_rate: 0
STMicroelectronics LIRC driver initialized.
STMicroelectronics ASC driver initialized
stm-asc.0: ttyAS0 at MMIO 0xfd032000 (irq = 121) is a stm-asc
Uniform Multi-Platform E-IDE driver
ide-gd driver 1.18
MiPHY driver style MiPHY3-65 probed successfully
MiPHY3-65, c1.5 Claimed by sata-stm
scsi0 : sata-stm
ata1: SATA max UDMA/133 irq 72
ata1: SATA link down (SStatus 0 SControl 0)
stmmac - user ID: 0x10, Synopsys ID: 0x33
No HW DMA feature register supported
Enhanced/Alternate descriptors
RX Checksum Offload Engine supported
TX Checksum insertion supported
Wake-Up On Lan supported
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP BSD Compression module registered
PPP MPPE Compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V1.0
usbmon: debugfs is not available
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
stm_usb_probe: usb_phy_clk clock not found for stm-usb.0
stm-ehci stm-ehci.0: STMicroelectronics EHCI Host Controller
stm-ehci stm-ehci.0: new USB bus registered, assigned bus number 1
stm-ehci stm-ehci.0: irq 169, io mem 0xfe1ffe00
stm-ehci stm-ehci.0: USB 0.0 started, EHCI 1.00
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
stm-ohci stm-ohci.0: STMicroelectronics OHCI Host Controller
stm-ohci stm-ohci.0: new USB bus registered, assigned bus number 2
stm-ohci stm-ohci.0: irq 168, io mem 0xfe1ffc00
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
stm_usb_probe: usb_phy_clk clock not found for stm-usb.1
stm-ehci stm-ehci.1: STMicroelectronics EHCI Host Controller
stm-ehci stm-ehci.1: new USB bus registered, assigned bus number 3
stm-ehci stm-ehci.1: irq 143, io mem 0xfeaffe00
stm-ehci stm-ehci.1: USB 0.0 started, EHCI 1.00
usb usb3: configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 1 port detected
stm-ohci stm-ohci.1: STMicroelectronics OHCI Host Controller
stm-ohci stm-ohci.1: new USB bus registered, assigned bus number 4
stm-ohci stm-ohci.1: irq 142, io mem 0xfeaffc00
usb usb4: configuration #1 chosen from 1 choice
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 1 port detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
sh_tmu: TMU0 kept as earlytimer
sh_tmu: TMU1 kept as earlytimer
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
STMicroelectronics - Coprocessors st231 Init
st-coprocessor-0: No RAM reserved
st231.0 Coprocessor -------------------------------------------
not configured!
---------------------------------------------------------------
st-coprocessor-1: No RAM reserved
st231.1 Coprocessor -------------------------------------------
not configured!
---------------------------------------------------------------
stm-rng hardware driver 1.0 configured
TCP cubic registered
NET: Registered protocol family 17
usb 1-1: new high speed USB device using stm-ehci and address 2
usb 1-1: configuration #1 chosen from 1 choice
scsi1 : SCSI emulation for USB Mass Storage devices
eth0: device MAC address de:ea:ff:ff:01:01
STMMAC MII Bus: probed
eth0: PHY ID 01018f2d at 17 IRQ 0 (0:11) active
stmmac_timer: (eth0) sh_tmu Timer (freq 256Hz)
No MAC Management Counters available
IP-Config: Complete:
device=eth0, addr=192.168.100.5, mask=255.255.255.0, gw=192.168.100.1,
host=sh4, domain=, nis-domain=(none),
bootserver=192.168.100.1, rootserver=192.168.100.1, rootpath=
PHY: 0:11 - Link is Up - 100/Full
scsi 1:0:0:0: Direct-Access General USB Flash Disk 1100 PQ: 0 ANSI: 0 CCS
sd 1:0:0:0: Attached scsi generic sg0 type 0
sd 1:0:0:0: [sda] 15679488 512-byte logical blocks: (8.02 GB/7.47 GiB)
sd 1:0:0:0: [sda] Write Protect is off
sd 1:0:0:0: [sda] Assuming drive cache: write through
sd 1:0:0:0: [sda] Assuming drive cache: write through
sda: sda1 sda2
sd 1:0:0:0: [sda] Assuming drive cache: write through
sd 1:0:0:0: [sda] Attached SCSI removable disk
Looking up port of RPC 100003/2 on 192.168.100.1
Looking up port of RPC 100005/1 on 192.168.100.1
VFS: Mounted root (nfs filesystem) on device 0:13.
Freeing unused kernel memory: 148k freed
INIT: version 2.88 booting
[info] Using makefile-style concurrent boot in runlevel S.
[ ok ] Starting the hotplug events dispatcher: udevd.
[ ok ] Synthesizing the initial hotplug events...done.
[ ok ] Waiting for /dev to be fully populated...done.
[ ok ] Activating swap...done.
[ ok ] Cleaning up temporary files... /tmp.
[ ok ] Activating lvm and md swap...done.
[....] Checking file systems...fsck from util-linux 2.20.1
done.
[ ok ] Mounting local filesystems...done.
[ ok ] Activating swapfile swap...done.
[ ok ] Cleaning up temporary files....
[ ok ] Setting kernel variables ...done.
[....] Configuring network interfaces...Internet Systems Consortium DHCP Client 4.2.2
Copyright 2004-2011 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/software/dhcp/
Listening on LPF/eth0/de:ea:ff:ff:01:01
Sending on LPF/eth0/de:ea:ff:ff:01:01
Sending on Socket/fallback
DHCPREQUEST on eth0 to 255.255.255.255 port 67
DHCPREQUEST on eth0 to 255.255.255.255 port 67
DHCPREQUEST on eth0 to 255.255.255.255 port 67
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment