SuperPiBoy boot/config.txt

config.txt

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
overscan_left=-10
overscan_right=-10
overscan_top=-12
overscan_bottom=-10

# uncomment to force a console size. By default it will be display's size minus
# overscan.
framebuffer_width=640
framebuffer_height=480

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
arm_freq=950
core_freq=450
sdram_freq=450
gpu_mem=384


sdtv_aspect=2
# for more options see http://elinux.org/RPi_config.txt
overscan_scale=1
avoid_safe_mode=1
over_voltage=2