The client file for the Thingsquare firmware SDK used for the demo binaries.

client-launchpad.c

#include "thsq.h"
#include "ti-lib.h"
#include "gpio-interrupt.h"
#include "lib/sensors.h"
#include "batmon-sensor.h"
#include "dev/leds-arch.h"
#include "dev/cc26xx-uart.h"
/*---------------------------------------------------------------------------*/
void
init_leds(void)
{
  leds_arch_set_pins(IOID_6, IOID_7, IOID_UNUSED);
}
/*---------------------------------------------------------------------------*/
void
init_uart(void)
{
  cc26xx_uart_init(IOID_3, IOID_2, IOID_UNUSED, IOID_UNUSED);
}
/*---------------------------------------------------------------------------*/
static void
callback_thsq(enum thsq_reason r, const char *msg, int len)
{
  if(r == THSQ_PERIOD) {
    int value;
    value = batmon_sensor.value(BATMON_SENSOR_TYPE_VOLT);
    thsq_sset_printf("b", "%d.%03d", value / 1000, value % 1000);

    thsq_sset("t", batmon_sensor.value(BATMON_SENSOR_TYPE_TEMP));
    thsq_push();
  }
}
/*---------------------------------------------------------------------------*/
void
app(void)
{
  /* Initialize the lighting module */
  thsq_lighting_init();
  thsq_lighting_set_lamp();

  /* Initialize the configurable GPIO module */
  thsq_gpio_init();

  /* Make the GPIO module listen to events from the lighting module. */
  thsq_gpio_attach_lighting();

  /* Configure GPIO module PWMs, called from lighting module. We set
     the PWM to run on the RED LED, which is on the IOID_6 pin. */
  thsq_pwm_cc26xx_cc13xx_conf(thsq_gpio_get_pwm_red(), IOID_6,
                              5000UL, GPT0_BASE, 0);

  /* Restore lighting settings from before last reboot. This must be
     called after attaching the GPIO module to the lighting module to
     make the lighting settings be transported to the GPIO module. */
  thsq_lighting_apply_last();

  /* Initialize the serial input/output module */
  thsq_serialline_init();

  /* Setup the periodic callback for the temperature sensor */
  static struct thsq_callback cb;
  thsq_add_callback(&cb, callback_thsq);
  SENSORS_ACTIVATE(batmon_sensor);

  /* Allow the device to be used as a packet sniffer */
  thsq_sniffer_init();
}
/*---------------------------------------------------------------------------*/