stellasphere

{
	"0":{
		"day":{
			"description":"Sunny",
			"image":"http://openweathermap.org/img/wn/01d@2x.png"
		},
		"night":{
			"description":"Clear",
			"image":"http://openweathermap.org/img/wn/01n@2x.png"
		}

imneonizer

How to download from pan.baidu.com

Disclaimer:

• This methods uses a 3rd party website: https://baidu.kinh.cc/.
• I don't know chinese and after one day of searching for a method I finally found this. I don't know how safe this website is but it does the job.
• Do it on your own responsibility. I have no idea about possible copyright (if there is such a thing in China) and other stuff regarding to this.

Steps

1. Open the website mentioned above and fill out fields as following:

mbaezner

WireGuard Routing without NAT

WireGuard Configuration

Remove the iptables masquerade rule from the post-up and post-down section of the WireGuard configuraiton file.

iptables -t nat -A POSTROUTING -o {{ lan_interface }} -j MASQUERADE

luukvbaal

[Trigger]
Operation = Remove
Type = Package
Target = *

[Action]
Description = Clearing cache...
When = PostTransaction
Exec = /home/<user>/.local/bin/tools/removehook

noushi

An Ansible summary

Jon Warbrick, July 2014, V3.2 (for Ansible 1.7)

Configuration file

intro_configuration.html

First one found from of

dianjuar

Restore the GRUB Bootloader on Manjaro

1. Chroot into your linux instalation
   1. The easiest way is with mhwd-chroot
      1. Install it yaourt -S mhwd-chroot
      2. Run it sudo mhwd-chroot
      3. DONE, you have chrooted into your linux installation (open a root console of your installed linux OS, is like just open a console with root access)
2. Restore your GRUB
   1. Install a new GRUB bootloader with grub-install /dev/sda
3. Recheck to ensure the that installation has completed without any errors grub-install --recheck /dev/sda

gbaman

Raspberry Pi Zero OTG Mode

Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).

The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int