luispabon

• Based on https://gist.github.com/mdziekon/221bdb597cf32b46c50ffab96dbec08a
• Installation date: 16-08-2019
• Additional notes based on my own experience
• EFI boot
• Ubuntu 19.04 -> 21.04
• This should work on any computer. Only the RAID > AHCI change described below and the device name for the nvme ssd drive are specific to this laptop.
• The process describes a completely fresh installation with complete repartitioning, however it should work fine when Windows is already installed (eg. brand new machine with Windows preinstalled) as long as Windows already boots with EFI.
• The process was conducted on Dell's XPS 15 9560 (2017) with specs:
• CPU: i7-7700HQ

jamesmacwhite

Workarounds for Netflix and the blocking of Hurricane Electric IPv6 tunnels

The dreaded "You seem to be using an unblocker or proxy." error message. Cool story bro.

This gist was essentially created out of my own rant about Netflix being hostile to IPv6 tunnel services since June 2016. You are welcome to read my opinion on the matter, this is the more technical side to the issue and how to combat it within your own network.

Since I wrote this, various GitHub users have contributed their thoughts and ideas which has been incorporated into this gist. Thank you to everyone who have contributed their own methods and implementations.

The problem

Netflix now treats IPv6 tunnel brokers (such as Hurricane Electric) as proxy servers. A while ago it became apparent to users and Netflix that somewhat by accident, IPv6 tunnel users were being served content outside of their geolocation because of the way Netflix was identifyi

rys

# this assumes WAN is eth0 and LAN is switch0. Please adjust for your own setup

configure

# Tunnel first
edit interfaces tunnel tun0
set encapsulation sit
set local-ip xxx.xxx.xxx.xxx # your WAN IP
set remote-ip xxx.xxx.xxx.xxx # HE.net Server IPv4 Address
set address xxxx:xxxx:xxxx:xxxx::2/64 # Client IPv6 Address

marlun78

# How to install `ipkg` on a Synology DS214

After a couple of days of trying to get `ipkg` woking on my DS214 I found [this article](https://github.com/trepmag/ds213j-optware-bootstrap) by [trepmag](https://github.com/trepmag). It is written for the DS213j, but it’s been working for me and [others](https://github.com/alberthild) for the DS214 too. 

I have done some minor changed to clarify some things, but if you are a Linux guy (unlike me) my changes might be of no use to you. 


## Guide