Skip to content

Instantly share code, notes, and snippets.

@nightBulb
Created July 18, 2019 22:34
Show Gist options
  • Star 0 You must be signed in to star a gist
  • Fork 0 You must be signed in to fork a gist
  • Save nightBulb/6f6ef85d94d75a63676479f5687d5318 to your computer and use it in GitHub Desktop.
Save nightBulb/6f6ef85d94d75a63676479f5687d5318 to your computer and use it in GitHub Desktop.
raspinfo
System Information
------------------
Raspberry Pi 2 Model B Rev 1.1
NAME="Arch Linux ARM"
PRETTY_NAME="Arch Linux ARM"
ID=archarm
ID_LIKE=arch
Linux rpi 4.19.57-1-ARCH #1 SMP PREEMPT Fri Jul 5 19:10:19 UTC 2019 armv7l GNU/Linux
Hardware : BCM2835
Revision : a01041
Serial : 0000000011be05f4
Throttled flag : throttled=0x0
Camera : supported=0 detected=0
Videocore information
---------------------
Jul 5 2019 19:05:26
Copyright (c) 2012 Broadcom
version 52869c215483abb3227faaaa86837e606811c72c (clean) (release) (start)
alloc failures: 0
compactions: 0
legacy block fails: 0
Filesystem information
----------------------
Filesystem 1K-blocks Used Available Use% Mounted on
dev 470236 0 470236 0% /dev
run 478052 380 477672 1% /run
/dev/sda1 7561876 4152644 3002068 59% /
tmpfs 478052 0 478052 0% /dev/shm
tmpfs 478052 0 478052 0% /sys/fs/cgroup
tmpfs 478052 8 478044 1% /tmp
/dev/mmcblk0p1 102182 38450 63732 38% /boot
/dev/sdb1 [redacted]
/dev/sdc1 [redacted]
/dev/sde1 [redacted]
/dev/sdd1 [redacted]
/dev/sdd1 [redacted]
tmpfs 95608 0 95608 0% /run/user/1000
Filename Type Size Used Priority
Package version information
---------------------------
Networking Information
----------------------
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet x.x.x.x netmask x.x.x.x broadcast x.x.x.x
inet6 yyyy::yyyy:yyyy:yyyy:5f4 prefixlen 64 scopeid 0x20<link>
ether zz:zz:zz:zz:zz:f4 txqueuelen 1000 (Ethernet)
RX packets 3386 bytes 1037842 (1013.5 KiB)
RX errors 0 dropped 1 overruns 0 frame 0
TX packets 2959 bytes 434015 (423.8 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet x.x.x.x netmask x.x.x.x
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 86 bytes 7394 (7.2 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 86 bytes 7394 (7.2 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
[ 4.559387] usbcore: registered new interface driver lan78xx
[ 0.000000] Kernel command line: coherent_pool=1M bcm2708_fb.fbwidth=1824 bcm2708_fb.fbheight=984 bcm2708_fb.fbswap=1 vc_mem.mem_base=0x3ec00000 vc_mem.mem_size=0x40000000 root=PARTUUID=a019b6db-6aa2-4d70-a87d-367c6ebfadd7 rw rootwait console=ttyAMA0,115200 console=tty1 selinux=0 plymouth.enable=0 smsc95xx.turbo_mode=N dwc_otg.lpm_enable=0 kgdboc=ttyAMA0,115200 elevator=noop rootdelay=5
[ 4.559933] usbcore: registered new interface driver smsc95xx
[ 7.270525] smsc95xx v1.0.6
[ 7.370484] smsc95xx 1-1.1:1.0 eth0: register 'smsc95xx' at usb-3f980000.usb-1.1, smsc95xx USB 2.0 Ethernet, b8:27:eb:be:05:f4
[ 16.774261] smsc95xx 1-1.1:1.0 eth0: hardware isn't capable of remote wakeup
[ 18.391863] smsc95xx 1-1.1:1.0 eth0: link up, 100Mbps, full-duplex, lpa 0xCDE1
USB Information
---------------
/: Bus 01.Port 1: Dev 1, Class=root_hub, Driver=dwc_otg/1p, 480M
|__ Port 1: Dev 2, If 0, Class=Hub, Driver=hub/5p, 480M
|__ Port 1: Dev 3, If 0, Class=Vendor Specific Class, Driver=smsc95xx, 480M
|__ Port 2: Dev 4, If 0, Class=Mass Storage, Driver=usb-storage, 480M
|__ Port 4: Dev 5, If 0, Class=Hub, Driver=hub/7p, 480M
|__ Port 2: Dev 7, If 0, Class=Mass Storage, Driver=usb-storage, 480M
|__ Port 7: Dev 10, If 0, Class=Mass Storage, Driver=usb-storage, 480M
|__ Port 1: Dev 6, If 0, Class=Mass Storage, Driver=usb-storage, 480M
|__ Port 6: Dev 9, If 0, Class=Mass Storage, Driver=usb-storage, 480M
config.txt
----------
gpu_mem=64
initramfs initramfs-linux.img followkernel
cmdline.txt
-----------
root=PARTUUID=[redacted] rw rootwait console=ttyAMA0,115200 console=tty1 selinux=0 plymouth.enable=0 smsc95xx.turbo_mode=N dwc_otg.lpm_enable=0 kgdboc=ttyAMA0,115200 elevator=noop rootdelay=5
raspi-gpio settings
-------------------
vcdbg log messages
------------------
000983.751: brfs: File read: /mfs/sd/config.txt
000984.122: brfs: File read: 109 bytes
001060.293: brfs: File read: /mfs/sd/config.txt
001060.672: gpioman: gpioman_get_pin_num: pin LEDS_PWR_OK not defined
001070.633: gpioman: gpioman_get_pin_num: pin WL_LPO_CLK not defined
001070.704: gpioman: gpioman_get_pin_num: pin BT_ON not defined
001070.768: gpioman: gpioman_get_pin_num: pin WL_ON not defined
001245.580: gpioman: gpioman_get_pin_num: pin DISPLAY_DSI_PORT not defined
001246.856: gpioman: gpioman_get_pin_num: pin LEDS_PWR_OK not defined
001246.945: *** Restart logging
001247.007: brfs: File read: 109 bytes
001277.501: hdmi: HDMI:hdmi_get_state is deprecated, use hdmi_get_display_state instead
001278.781: brfs: File read: /mfs/sd/cmdline.txt
001278.894: Read command line from file 'cmdline.txt':
001278.961: 'root=PARTUUID=[redacted] rw rootwait console=ttyAMA0,115200 console=tty1 selinux=0 plymouth.enable=0 smsc95xx.turbo_mode=N dwc_otg.lpm_enable=0 kgdboc=ttyAMA0,115200 elevator=noop rootdelay=5'
001279.288: brfs: File read: 218 bytes
001738.974: brfs: File read: /mfs/sd/kernel7.img
001739.040: Loading 'kernel7.img' to 0x8000 size 0x74c978
001739.121: brfs: File read: 7653752 bytes
002126.036: brfs: File read: /mfs/sd/initramfs-linux.img
002126.097: Loading 'initramfs-linux.img' to 0x754978 size 0x643adb
002901.187: No kernel trailer - assuming DT-capable
002901.277: brfs: File read: 6568667 bytes
002905.256: brfs: File read: /mfs/sd/bcm2709-rpi-2-b.dtb
002905.317: Loading 'bcm2709-rpi-2-b.dtb' to 0x754978 size 0x62cd
003064.539: brfs: File read: 25293 bytes
003065.051: brfs: File read: /mfs/sd/config.txt
005074.615: gpioman: gpioman_get_pin_num: pin EMMC_ENABLE not defined
005173.771: Device tree loaded to 0x2e9b5800 (size 0x6738)
005175.530: gpioman: gpioman_get_pin_num: pin SDCARD_CONTROL_POWER not defined
011170.246: vchiq_core: vchiq_init_state: slot_zero = 0xfb980000, is_master = 1
011175.115: hdmi: HDMI:hdmi_get_state is deprecated, use hdmi_get_display_state instead
011180.737: TV service:host side not connected, dropping notification 0x00000002, 0x00000001, 0x00000010
022410.310: brfs: File read: 109 bytes
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment