boot.config

gistfile1.txt

# For more options and information see
# http://rpf.io/configtxt
# Some settings may impact device functionality. See link above for details

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# Disable rainbow image at boot
disable_splash=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
hdmi_group=1
hdmi_mode=16

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
arm_freq=2000
gpu_freq=600
over_voltage=6

# Uncomment some or all of these to enable the optional hardware interfaces
dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Uncomment this to enable infrared communication.
#dtoverlay=gpio-ir,gpio_pin=17
#dtoverlay=gpio-ir-tx,gpio_pin=18

# Additional overlays and parameters are documented /boot/overlays/README

# Enable audio (loads snd_bcm2835)
dtparam=audio=on

[pi4]
# Enable DRM VC4 V3D driver on top of the dispmanx display stack
dtoverlay=vc4-fkms-v3d
max_framebuffers=2

[all]
#dtoverlay=vc4-fkms-v3d
dtoverlay=vc4-kms-v3d

overscan_scale=1
enable_uart=1
ignore_lcd=1
dtparam=sd_poll_once
dtparam=i2c_vc=on
dtoverlay=WS_xinchDSI_Screen,SCREEN_type=2,I2C_bus=1
dtoverlay=WS_xinchDSI_Touch,I2C_bus=1

#Enable DSI LCD and HDMI mirror by Craig 20230809
enable_tvout=1

#Enable touch rotation
#90
dtoverlay=WS_xinchDSI_Touch,invertedx,swappedxy,I2C_bus=1
#180
dtoverlay=WS_xinchDSI_Touch,invertedx,invertedy,I2C_bus=1
#270
dtoverlay=WS_xinchDSI_Touch,invertedy,swappedxy,I2C_bus=1
#0
dtoverlay=WS_xinchDSI_Touch,I2C_bus=1