gistfile1.txt

---
# This parser will parse the output from 'show running-config' on Cisco NXOS.
#
# Command: show running-config
# Platform: nxos
#
# Returns:
#   interfaces:
#     name: The name of the interface
#     ipv4: The IPv4 address (if configured)
#     ipv6: The IPv6 address (if configured)
#     enabled: Whether or not the interface is administratively enabled
#     description: The configured interface description
#     vrf: The interface VRF (if configured)
#     switchport: Whether or not the interface is configured as switchport
#     acl_in: The name of in inbound ACL (if configured)
#     acl_out: The name of the outbound ACL (if configured)
#
# Example:
#   - nxos_command:
#       commands: show interface
#     register: output
#
#   - set_fact:
#       interface-config: "{{ output.stdout[0] | parse_cli('interface-config.yaml') }}"
#
vars:
  interface:
    name: "{{ item[0].name }}"
    ipv4: "{{ item[1].match[0] }}"
    ipv6: "{{ item[8].match[0] }}"
    enabled: "{{ item[2] != None }}"
    description: "{{ item[3].match[0] }}"
    vrf: "{{ item[4].match[0] }}"
    switchport: "{{ item[5].match[0] == None }}"
    acl_in: "{{ item[6].match[0] }}"
    acl_out: "{{ item[7].match[0] }}"
    mac_address: "{{ item[9].match[0] }}"

keys:
  interfaces:
    value: "{{ interface }}"
    start_block: "^interface .*$"
    end_block: "^$"
    items:
      - "^interface (?P<name>.+)"
      - "ip address (.+)"
      - "no shutdown"
      - "description (.+)"
      - "vrf member (.+)"
      - "no switchport"
      - "ip access-group (.+) in"
      - "ip access-group (.+) out"
      - "ipv6 address (.+)"
      - "mac-address (.+)"