ChipCE

READ THIS FIRST

Adaptive bed mesh is merged into klipper master branch. You can use this feature without this custom macro. Official klipper adaptive bed mesh

Klipper mesh on print area only install guide

What this macro do

• This macro will dynamically changing the bed mesh area based on the size of the parts will be printed. The fw will only probe on the area that the part will be printed (plus mesh_area_offset value)

exocode

Quadcopter and Betaflight cheat sheet

Introduction

On my yourney though hundreds of videos, tutorials and manuals (Bardwell, UAV Tech, JohnnyFPV, Mr. Steele, Le Drib, RotorRiot (sorry, for the missed ones) and wrote down their suggestions). This is the result of my notes. It should provide the least necessary but most compressed information to start tuning and setting your Quadcopter. In my case I use the widely spread Taranis X7 remote control.

I am a freestyle pilot, so keep in mind, that these settings are in this scope (more smooth, softer flight behaviour).

Remote Control (Taranis X7)