ratanlivebd

## atem-controller.ino
#include <Ethernet2.h>
#include <SPI.h>
#include <SkaarhojPgmspace.h>


// MAC address and IP address for this *particular* Arduino / Ethernet Shield!
// The MAC address is printed on a label on the shield or on the back of your device
// The IP address should be an available address you choose on your subnet where the switcher is also present
byte mac[] = { 0x90, 0xA2, 0xDA, 0x10, 0x0B, 0x68 };      // <= SETUP!  MAC address of the Arduino
IPAddress clientIp(192, 168, 10, 99);        // <= SETUP!  IP address of the Arduino
	#include <Ethernet2.h>
	#include <SPI.h>
	#include <SkaarhojPgmspace.h>


	// MAC address and IP address for this particular Arduino / Ethernet Shield!
	// The MAC address is printed on a label on the shield or on the back of your device
	// The IP address should be an available address you choose on your subnet where the switcher is also present
	byte mac[] = { 0x90, 0xA2, 0xDA, 0x10, 0x0B, 0x68 }; // <= SETUP! MAC address of the Arduino
	IPAddress clientIp(192, 168, 10, 99); // <= SETUP! IP address of the Arduino