Chip Eye Blink

chip-eye-blink

// Chip has 3 important pins
// Ground (GND) -- plugged into to Arduino GND
// Right Eye LED (D10) --> plugged into to Arduino D10
// Left Eye LED (D11) --> plugged into to Arduino D11
//
// We need to define Chip's eyes so we can use them in our code
 
int rEye = 10; //define right eye as pin10 on the Arduino
int lEye = 11; //define right eye as pin11 on the Arduino
 
// Next we need to initialize the Arduino pins
// setup() only runs once when you power on or reset an Arduino
 
void setup(){
  pinMode(rEye, OUTPUT); //set right eye for output
  pinMode(lEye, OUTPUT); //set left eye for output
}
 
//loop() runs forever - this is our main code
void loop(){
 
  // turn both eyes on. HIGH means set voltage to HIGH
  digitalWrite(rEye, HIGH);
  digitalWrite(lEye, HIGH);
 
  delay (1000); //wait for 1 second. Delay is set in miliseconds or 1/1000 of a second
 
  // turn right eye off. LOW means set voltage to LOW.
  digitalWrite(rEye, LOW);

  delay (1000); //wait for 1 second. Delay is set in miliseconds or 1/1000 of a second
 
  // turn left eye off. LOW means set voltage to LOW.
  digitalWrite(lEye, LOW);

  delay (1000); //wait for 1 second. Delay is set in miliseconds or 1/1000 of a second
 
  // we are at end of loop - we go back to the beginning
}