A320 "checklist"

a320-checklist.md

Check List

Check this first

• Landing gear down
• breaks
• Whispers off
• Engine siwtches OFF
• selector Normal
• Batery vtg > 25.5

Initial Setup

• Bat 1 y 2
• External Power
• Turn on lights
  • Emergency
  • Seat and cigar
  • Nav and Logo
• Crew supply oxygen
• Ground CTL
• ATIRS 1-3-2
• Fuel pumps

MCDU + EFB (tablet) (asumming SimBrief is setup)

• EFB Sync (Dashboard)
• Ground Services (if needed)
• Sync Payload
  • Hit Apply

MCDU

• Menu -> ATSU -> PilotID

• Init

  • Request FP
  • Set flight number
  • Set Cost Index

• F-Plan

  • Adjust Departure
    • Select RW
    • Select SID
    • Check in the monitor
      • Switch selector to PLAN,
      • Adjust radous
      • Activate constraints

• Init Again, B page (press <-)

  • Adjust BLOCK (Use FOB, example 5380 => 5.4)
  • Adjust ZFW (just press the soft key)
  • Adjust trip wind (check AVG W/C in SB PDF)

• Performance (EFB) (calculate on tablet)

  • Sync
  • Select RW
  • Confirm/Set weight (FUEL PRED, GW en el MCDU)
  • Set flaps 1
  • Calculate and send to FMGS
  • Confirm in the performance page
  • Set flaps y THS

• Adjust QHN and transition altitude

APU Startup

• Master Siwtch ON
  • Wait 3 seconds and press START
    • Check APU page
    • Once available,
      • disconnect Ext. Power
      • Activate APU bleed
      • Beacon light ON
      • Remove GPU (EFB ground)
      • Remove chunks

Engine Start & Taxi

• Check Thrust IDLE
• Check Breaks ON
• Check Landing Gear
• Set Engine Switch to Ignite
• Start eng. 2 and then eng. 1 (one 2 is available - a320 support dual start)
• Once both are ready
  • APU bleed OFF
  • APU master switch OFF

Ready to Taxi

• Taxi lights ON
• Runway lights on
• Speed breaks armed
• Flaps 1 (this depends on the config)
• Auto breaks max
• Flight controls check (see the FC page)
• Trim to Zero

Before TakeOff

• Taxi light off
• Landing lights on
• TCAS TI/RA