CPE210v2 LEDE

gistfile1.txt

U-Boot 1.1.4-g30d8afa8-dirty (Nov  1 2016 - 17:38:05)

ap143-2.0 - Honey Bee 2.0

DRAM:  64 MB
Flash Manuf Id 0xc8, DeviceId0 0x40, DeviceId1 0x17
flash size 8MB, sector count = 128
Flash:  8 MB
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ath_gmac_enet_initialize...
ath_gmac_enet_initialize: reset mask:c02200
Scorpion ---->S27 PHY*
S27 reg init
: cfg1 0x800c0000 cfg2 0x7114
eth0: ba:be:fa:ce:08:41
athrs27_phy_setup ATHR_PHY_CONTROL 4 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 4 :10
eth0 up
Honey Bee ---->  MAC 1 S27 PHY *
S27 reg init
ATHRS27: resetting s27
ATHRS27: s27 reset done
: cfg1 0x800c0000 cfg2 0x7214
eth1: ba:be:fa:ce:08:41
athrs27_phy_setup ATHR_PHY_CONTROL 0 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 0 :10
athrs27_phy_setup ATHR_PHY_CONTROL 1 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 1 :10
athrs27_phy_setup ATHR_PHY_CONTROL 2 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 2 :10
athrs27_phy_setup ATHR_PHY_CONTROL 3 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 3 :10
eth1 up
eth0, eth1
Setting 0x181162c0 to 0x50a1a100
is button pressed? 0
Autobooting in 1 seconds
## Booting image at 9f040000 ...
   Uncompressing Kernel Image ... OK

Starting kernel ...

[    0.000000] Linux version 4.4.91 (robimarko@Builder) (gcc version 5.4.0 (LEDE GCC 5.4.0 r5071-c1de868) ) #0 Sat Oct 14 09:37:38 2017
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU0 revision is: 00019374 (MIPS 24Kc)
[    0.000000] SoC: Qualcomm Atheros QCA9533 ver 2 rev 0
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 04000000 @ 00000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] No valid device tree found, continuing without
[    0.000000] Zone ranges:
[    0.000000]   Normal   [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
[    0.000000] Kernel command line:  board=CPE210V2 mtdparts=spi0.0:128k(u-boot)ro,64k(pation-table)ro,64k(product-info)ro,1536k(kernel),6144k(rootfs),192k(config)ro,64k(ART)ro,7680k@0x40000(firmware) console=ttyS0,115200 rootfstype=squashfs noinitrd
[    0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[    0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[    0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[    0.000000] Writing ErrCtl register=00000000
[    0.000000] Readback ErrCtl register=00000000
[    0.000000] Memory: 60100K/65536K available (2996K kernel code, 144K rwdata, 756K rodata, 320K init, 200K bss, 5436K reserved, 0K cma-reserved)
[    0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] NR_IRQS:51
[    0.000000] Clocks: CPU:650.000MHz, DDR:390.771MHz, AHB:216.666MHz, Ref:25.000MHz
[    0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5880801374 ns
[    0.000009] sched_clock: 32 bits at 325MHz, resolution 3ns, wraps every 6607641598ns
[    0.008250] Calibrating delay loop... 432.53 BogoMIPS (lpj=2162688)
[    0.071113] pid_max: default: 32768 minimum: 301
[    0.076127] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.083114] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.093848] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[    0.104282] futex hash table entries: 256 (order: -1, 3072 bytes)
[    0.111597] NET: Registered protocol family 16
[    0.118126] MIPS: machine is TP-LINK CPE210 v2
[    0.350613] clocksource: Switched to clocksource MIPS
[    0.357542] NET: Registered protocol family 2
[    0.363088] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[    0.370459] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[    0.377246] TCP: Hash tables configured (established 1024 bind 1024)
[    0.384091] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    0.390272] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    0.397312] NET: Registered protocol family 1
[    0.407165] Crashlog allocated RAM at address 0x3f00000
[    0.429067] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    0.435314] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[    0.448706] io scheduler noop registered
[    0.452923] io scheduler deadline registered (default)
[    0.458668] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[    0.465915] console [ttyS0] disabled
[    0.489853] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11, base_baud = 1562500) is a 16550A
[    0.498965] console [ttyS0] enabled
[    0.498965] console [ttyS0] enabled
[    0.506520] bootconsole [early0] disabled
[    0.506520] bootconsole [early0] disabled
[    0.519011] m25p80 spi0.0: found gd25q64, expected m25p80
[    0.524704] m25p80 spi0.0: gd25q64 (8192 Kbytes)
[    0.531134] spi0.0: no TP-Link header found
[    0.535472] mtd: failed to find partitions; one or more parsers reports errors (-19)
[    0.571071] libphy: ag71xx_mdio: probed
[    1.163574] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd042, driver=Generic PHY]
[    1.173797] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:MII
[    1.182412] NET: Registered protocol family 10
[    1.191564] NET: Registered protocol family 17
[    1.196264] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this.
[    1.209510] 8021q: 802.1Q VLAN Support v1.8
[    1.217298] VFS: Cannot open root device "(null)" or unknown-block(0,0): error -6
[    1.225115] Please append a correct "root=" boot option; here are the available partitions:
[    1.233750] 1f00            8192 mtdblock0  (driver?)
[    1.238978] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)
[    1.248181] Rebooting in 1 seconds..