Bootlog after flashing LEDE

gistfile1.txt

Firmwave supports CPE210(TP-LINK|EU|N300-2|45550000):2.0, check OK..

UPGRADE: This might take several minutes.Please DO NOT POWER OFF the device!
#########################################################
Done.
umount: /var: Device or resource busy
umount: /tmp: Device or resource busy
The system is going down NOW !!httpd_ipc_fetch: Interrupted system call
Sending SIGKILL to all processes.
Please stand by while rebooting the system.
Restarting system.


U-Boot 1.1.4-g30d8afa8-dirty (Nov  1 2016 - 17:38:05)

ap143-2.0 - Honey Bee 2.0

DRAM:  64 MB
Flash Manuf Id 0xc8, DeviceId0 0x40, DeviceId1 0x17
flash size 8MB, sector count = 128
Flash:  8 MB
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ath_gmac_enet_initialize...
ath_gmac_enet_initialize: reset mask:c02200
Scorpion ---->S27 PHY*
S27 reg init
: cfg1 0x800c0000 cfg2 0x7114
eth0: ba:be:fa:ce:08:41
athrs27_phy_setup ATHR_PHY_CONTROL 4 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 4 :10
eth0 up
Honey Bee ---->  MAC 1 S27 PHY *
S27 reg init
ATHRS27: resetting s27
ATHRS27: s27 reset done
: cfg1 0x800c0000 cfg2 0x7214
eth1: ba:be:fa:ce:08:41
athrs27_phy_setup ATHR_PHY_CONTROL 0 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 0 :10
athrs27_phy_setup ATHR_PHY_CONTROL 1 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 1 :10
athrs27_phy_setup ATHR_PHY_CONTROL 2 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 2 :10
athrs27_phy_setup ATHR_PHY_CONTROL 3 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 3 :10
eth1 up
eth0, eth1
Setting 0x181162c0 to 0x50a1a100
is button pressed? 0
Autobooting in 1 seconds
## Booting image at 9f040000 ...
   Uncompressing Kernel Image ... OK

Starting kernel ...