Config as of 15-12-2011

gistfile1.txt

bottom_layer_speed_ratio = 0.7
bridge_flow_ratio = 1
bridge_speed = 60
duplicate_distance = 6
duplicate_x = 1
duplicate_y = 1
end_gcode = ; M104 S0 ; turn off temperature\nG28 X0  ; home X axis\nM84     ; disable motors
extrusion_axis = E
extrusion_multiplier = 1
extrusion_width_ratio = 0
filament_diameter = 1.8
fill_angle = 0
fill_density = .2
fill_pattern = rectilinear
first_layer_height_ratio = 1
g0 = 0
gcode_arcs = 0
infill_every_layers = 1
infill_speed = 60
layer_height = 0.2
nozzle_diameter = .35
overlap_ratio = 0
perimeter_speed = 40
perimeters = 3
print_center = 60,60
retract_before_travel = 2
retract_length = 1
retract_lift = 0
retract_restart_extra = 0
retract_speed = 18
rotate = 0
scale = 1
skirt_distance = 6
skirt_height = 1
skirts = 4
small_perimeter_speed = 30
solid_fill_pattern = rectilinear
solid_infill_speed = 60
solid_layers = 3
start_gcode = G92 X0 Y0 Z0 E0 ; RESET home coords
temperature = 180
travel_speed = 75
use_relative_e_distances = 0
z_offset = 0