mroderick

How to add an image to a gist

1. Create a gist if you haven't already.
2. Clone your gist:

   # make sure to replace `<hash>` with your gist's hash
   git clone https://gist.github.com/<hash>.git # with https
   git clone git@gist.github.com:<hash>.git     # or with ssh

Tenzer

LastPass Pwned Passwords checker

This is a script for checking if any of the passwords you have stored in LastPass have been exposed through previous data breaches.

To use the script you need to have Python 3 installed and you need a CSV export of your LastPass vault. The export can be generated from the LastPass CLI with:

lpass export > lastpass.csv

or can be extracted with the browser plugin by going to the LastPass icon → More Options → Advanced → Export → LastPass CSV File (note that I did have problems getting this to work).

rikka0w0

The Digilent JTag uses FT2232, but its configuration EEPROM contains secrete data needed to be recoginzed by Xilinx ISE/Vivado. The following method only works on linux (tested on Ubuntu16.04), but the patched FT2232 doggle also works on Windows. Since WSL1 does not provide USB device access, the following method will not work for WSL1.

DONT use FT_Prog on offical Digilent cable, as it can trash the firmware! The offical eeprom contains secrete data that cannot be handled correctly by FT_Prog.

Here are steps to create a Digilent-like Jtag that can be used in Xilinx ISE and Vivado

1. Install softwares: sudo apt-get install libftdi1 ftdi-eeprom
2. Create a file "flash_digilent.conf" with the following content: