ryanbarrett
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| # -*- coding: utf-8 -*- | |
| # | |
| # Licensed under the Apache License, Version 2.0 (the "License"); | |
| # you may not use this file except in compliance with the License. | |
| # You may obtain a copy of the License at | |
| # | |
| # http://www.apache.org/licenses/LICENSE-2.0 | |
| # | |
| # Unless required by applicable law or agreed to in writing, software | |
| # distributed under the License is distributed on an "AS IS" BASIS, |
phyous
/ wpa_supplicant.conf
Created
December 16, 2012 00:46
proper config for raspberry pi File: /etc/wpa_supplicant/wpa_supplicant.conf
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev | |
| update_config=1 | |
| network={ | |
| ssid="__SSID__" | |
| proto=RSN | |
| key_mgmt=WPA-PSK | |
| pairwise=CCMP TKIP | |
| group=CCMP TKIP | |
| psk="__PASSWORD__" |
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| <!DOCTYPE html> | |
| <html> | |
| <head> | |
| <title>page title</title> | |
| </head> | |
| <body> | |
| page content | |
| </body> | |
| </html> |
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| #!/bin/sh | |
| # Quick start-stop-daemon example, derived from Debian /etc/init.d/ssh | |
| set -e | |
| # Must be a valid filename | |
| NAME=foo | |
| PIDFILE=/var/run/$NAME.pid | |
| #This is the command to be run, give the full pathname | |
| DAEMON=/usr/local/bin/bar |
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| startup_message off | |
| hardstatus on | |
| hardstatus alwayslastline | |
| hardstatus string "%{.bW}%-w%{..G}%n %t%{-}%+w %=%{..G} %H %{..Y} %m/%d %C%a" |