Padavan JWNR2010V5 Log

U-Boot 1.1.3 (Feb 26 2014 - 12:49:16)

Board: Ralink APSoC DRAM:  32 MB
enable ephy clock...done. rf reg 29 = 5
SSC disabled.
spi_wait_nsec: 29
spi device id: c2 20 16 c2 20 (2016c220)
find flash: MX25L3205D
*** Warning - bad CRC, using default environment

============================================
Ralink UBoot Version: 4.1.1.0
--------------------------------------------
ASIC 7620_MP (Port5<->None)
DRAM component: 256 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 32 MBytes
Flash component: SPI Flash
Date:Feb 26 2014  Time:12:49:16
============================================
icache: sets:512, ways:4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768

Press Ctrl+C to Enter the Main loop...


******************************************
    Uboot StandAlone Entry
******************************************                                    0
******************************************
    Uboot StandAlone Entry
******************************************
Enter NMRP_main
Flash Sector Number : 64.

 Waitting for RX_DMA_BUSY status Start... done


 ETH_STATE_ACTIVE!!
NMRP_FLASH_SIZE_buffer --> a1000000.
NMRP:LISTENING
### No NMRP Server found ###

******************************************
    Uboot StandAlone Entry
******************************************
Flash Sector Number : 64.

***************************************************
    Sercomm Boot Version 4.00.0

***************************************************
Entering Firmware : Everything is OK.

3: System Boot system code via Flash.
## Booting image at bc020000 ...
   Image Name:          JWNR2010V5
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    3452903 Bytes =  3.3 MB
   Load Address: 80000000
   Entry Point:  80243330
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK

Starting kernel ...


LINUX started...
Linux version 3.4.113 (padavan@hms) (gcc version 7.5.0 (crosstool-NG UNKNOWN) ) #3 Sat Aug 1 05:48:06 +06 2020
MediaTek SoC: MT7620N, RevID: 0206, RAM: DDR1, XTAL: 20MHz
CPU/OCP/SYS frequency: 600/200/200 MHz
CPU revision is: 00019650 (MIPS 24KEc)
Determined physical RAM map:
 memory: 02000000 @ 00000000 (usable)
Zone PFN ranges:
  Normal
0x00000000 -> 0x00002000
Movable zone start PFN for each node
Early memory PFN ranges
    0: 0x00000000 -> 0x00002000
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 8128
Kernel command line: console=ttyS0,57600n8
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Writing ErrCtl register=0005420b
Readback ErrCtl register=0005420b
Memory: 29484k/32768k available (2339k kernel code, 3284k reserved, 335k data, 204k init, 0k highmem)
NR_IRQS:40
console [ttyS0] enabled
Calibrating delay loop... 397.82 BogoMIPS (lpj=795648)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
msgmni has been set to 57
io scheduler noop registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x10000c00 (irq = 20) is a 16550A
Ralink GPIO driver initialized. Number of GPIO: 73, GPIO mode: 005A811D
loop: module loaded
Ralink SPI flash driver, SPI clock: 50MHz
SPI flash chip: MX25L3205D (c2 2016c220) (4096 Kbytes)
7 mtdsplitter partitions found on MTD device raspi
Creating 7 MTD partitions on "raspi":
0x000000000000-0x000000020000: "Bootloader"
0x000000020000-0x000000111670: "Kernel"
0x000000111670-0x0000003c0000: "RootFS"
mtd: device 2 (RootFS) set to be root filesystem
0x0000003c0000-0x0000003e0000: "Storage"
0x0000003e0000-0x0000003f0000: "Nvram"
0x0000003f0000-0x000000400000: "Factory"
0x000000020000-0x0000003e0000: "Firmware_Stub"
Ralink APSoC Ethernet Driver v3.2.4 (raeth)
raeth: PDMA RX ring 256, PDMA TX ring 512. Max packet size 1536
raeth: NAPI support, weight 32
raeth: Byte Queue Limits (BQL) support
PPP generic driver version 2.4.2
PPP MPPE Compression module registered
NET: Registered protocol family 24
PPTP driver version 0.8.5
nf_conntrack version 0.5.0 (8192 buckets, 16384 max)
xt_time: kernel timezone is -0000
Bridge firewalling registered
gre: GRE over IPv4 demultiplexor driver
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP: cubic registered
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
L2TP core driver, V2.0
PPPoL2TP kernel driver, V2.0
8021q: 802.1Q VLAN Support v1.8
ASUS NVRAM, v0.08. Available space: 61440. Integrity: MTD is empty
VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
Freeing unused kernel memory: 204k freed
Algorithmics/MIPS FPU Emulator v1.5
nvram_commit: write error
/dev/nvram: No such device
rt2860v2_ap: module license 'Proprietary' taints kernel.
APSoC AP Driver version: 2.7.2.0
chpasswd: password for 'admin' changed
raeth: HW IP/TCP/UDP checksum RX/TX offload enabled
raeth: HW VLAN TX offload enabled
raeth: HW Scatter/Gather TX offload enabled
mtk_esw - hw bridge: W|LLLL
mtk_esw - set broadcast storm control rate as: 10 mbps
device eth2.1 entered promiscuous mode
device eth2 entered promiscuous mode
 ch1 bssid=78:44:76:e8:2d:f8
 ch1 bssid=0c:80:63:b7:39:cc
 ch1 bssid=58:d5:6e:ea:16:da
 ch3 bssid=b0:be:76:41:76:26
 ch3 bssid=f4:f2:6d:4f:25:0c
 ch3 bssid=c8:3a:35:d9:a6:a0
 ch4 bssid=c0:a5:dd:1f:7d:84
 ch7 bssid=50:d2:f5:48:e3:40
 ch7 bssid=18:a6:f7:60:63:74
 ch8 bssid=f0:b4:d2:0e:df:c0
 ch8 bssid=ec:08:6b:60:48:8e
 ch9 bssid=d8:0d:17:64:04:26
 ch9 bssid=f4:f2:6d:d0:f5:20
 ch10 bssid=c4:71:54:24:d7:92
 ch10 bssid=18:a6:f7:99:3e:c6
 ch12 bssid=c8:3a:35:05:7e:51
 ch12 bssid=58:d5:6e:b0:5b:0f
=====================================================
Channel 1 : Dirty = 318, False CCA = 191, Busy Time = 0, Skip Channel = FALSE
Channel 2 : Dirty = 220, False CCA = 158, Busy Time = 0, Skip Channel = FALSE
Channel 3 : Dirty = 366, False CCA = 33, Busy Time = 0, Skip Channel = FALSE
Channel 4 : Dirty = 326, False CCA = 115, Busy Time = 0, Skip Channel = FALSE
Channel 5 : Dirty = 320, False CCA = 16, Busy Time = 0, Skip Channel = FALSE
Channel 6 : Dirty = 308, False CCA = 11729, Busy Time = 0, Skip Channel = FALSE
Channel 7 : Dirty = 392, False CCA = 3691, Busy Time = 0, Skip Channel = FALSE
Channel 8 : Dirty = 384, False CCA = 397, Busy Time = 0, Skip Channel = FALSE
Channel 9 : Dirty = 372, False CCA = 261, Busy Time = 0, Skip Channel = FALSE
Channel 10 : Dirty = 364, False CCA = 292, Busy Time = 0, Skip Channel = FALSE
Channel 11 : Dirty = 272, False CCA = 178, Busy Time = 0, Skip Channel = FALSE
Channel 12 : Dirty = 284, False CCA = 36, Busy Time = 0, Skip Channel = TRUE
Channel 13 : Dirty = 152, False CCA = 0, Busy Time = 0, Skip Channel = TRUE
=====================================================
Rule 1 CCA value : Min Dirtiness ==> Select Channel 13
Min Dirty = 152
ExChannel = 9 , 0
BW        = 40
device ra0 entered promiscuous mode
br0: port 2(ra0) entered forwarding state
br0: port 2(ra0) entered forwarding state
br0: port 1(eth2.1) entered forwarding state
br0: port 1(eth2.1) entered forwarding state
/sys/class/net/ra1/brport/isolate_mode: No such file or directory
mtk_esw - software IGMP/MLD snooping: 1
Ralink HW NAT v2.52.0 Module Enabled, FoE Size: 16384
rstats
Copyright (C) 2006-2009 Jonathan Zarate



BusyBox v1.31.1 (2020-08-01 02:24:31 +06) built-in shell (ash)
Enter 'help' for a list of built-in commands.

/ # br0: port 2(ra0) entered forwarding state
br0: port 1(eth2.1) entered forwarding state
event signal: User defined signal 1
rc notification: control_wifi_guest_rt_off
rc notification: control_wifi_radio_rt_on