Netgear JWNR2010v5 Openwrt #2

## Booting image at bc020000 ...
   Image Name:   MIPS OpenWrt Linux-4.14.187
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    1675471 Bytes =  1.6 MB
   Load Address: 80000000
   Entry Point:  80000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK

Starting kernel ...

[    0.000000] Linux version 4.14.187 (home@ubuntu) (gcc version 8.4.0 (OpenWrt GCC 8.4.0 r13884-1623defbdb)) #0 Mon Jul 20 19:34:44 2020
[    0.000000] Board has DDR1
[    0.000000] Analog PMU set to hw control
[    0.000000] Digital PMU set to hw control
[    0.000000] SoC Type: MediaTek MT7620N ver:2 eco:6
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU0 revision is: 00019650 (MIPS 24KEc)
[    0.000000] MIPS: machine is Netgear JWNR2010 v5
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 02000000 @ 00000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[    0.000000] Zone ranges:
[    0.000000]   Normal   [mem 0x0000000000000000-0x0000000001ffffff]
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x0000000000000000-0x0000000001ffffff]
[    0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000001ffffff]
[    0.000000] random: get_random_bytes called from start_kernel+0x98/0x4a4 with crng_init=0
[    0.000000] Built 1 zonelists, mobility grouping on.  Total pages: 8120
[    0.000000] Kernel command line: console=ttyS0,57600 rootfstype=squashfs,jffs2
[    0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[    0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[    0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[    0.000000] Writing ErrCtl register=00058008
[    0.000000] Readback ErrCtl register=00058008
[    0.000000] Memory: 25916K/32768K available (3925K kernel code, 187K rwdata, 896K rodata, 1192K init, 212K bss, 6852K reserved, 0K cma-reserved)
[    0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] NR_IRQS: 256
[    0.000000] CPU Clock: 580MHz
[    0.000000] clocksource: systick: mask: 0xffff max_cycles: 0xffff, max_idle_ns: 583261500 ns
[    0.000000] systick: enable autosleep mode
[    0.000000] systick: running - mult: 214748, shift: 32
[    0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6590553264 ns
[    0.000010] sched_clock: 32 bits at 290MHz, resolution 3ns, wraps every 7405115902ns
[    0.015464] Calibrating delay loop... 385.84 BogoMIPS (lpj=1929216)
[    0.087711] pid_max: default: 32768 minimum: 301
[    0.097161] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.110187] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.129958] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[    0.149437] futex hash table entries: 256 (order: -1, 3072 bytes)
[    0.161660] pinctrl core: initialized pinctrl subsystem
[    0.172491] NET: Registered protocol family 16
[    0.207851] rt2880_gpio 10000600.gpio: registering 24 gpios
[    0.218883] rt2880_gpio 10000600.gpio: registering 24 irq handlers
[    0.231442] rt2880_gpio 10000638.gpio: registering 16 gpios
[    0.242435] rt2880_gpio 10000638.gpio: registering 16 irq handlers
[    0.255025] rt2880_gpio 10000660.gpio: registering 32 gpios
[    0.266021] rt2880_gpio 10000660.gpio: registering 32 irq handlers
[    0.278610] rt2880_gpio 10000688.gpio: registering 1 gpios
[    0.289435] rt2880_gpio 10000688.gpio: registering 1 irq handlers
[    0.306912] clocksource: Switched to clocksource systick
[    0.318680] NET: Registered protocol family 2
[    0.328113] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[    0.341893] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[    0.354481] TCP: Hash tables configured (established 1024 bind 1024)
[    0.367264] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    0.378785] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    0.391539] NET: Registered protocol family 1
[    0.403000] rt-timer 10000100.timer: maximum frequency is 1220Hz
[    0.415794] Crashlog allocated RAM at address 0x1f00000
[    0.427985] workingset: timestamp_bits=14 max_order=13 bucket_order=0
[    0.447937] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    0.459442] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[    0.491213] io scheduler noop registered
[    0.498918] io scheduler deadline registered (default)
[    0.509883] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
[    0.523545] console [ttyS0] disabled
[    0.530605] 10000c00.uartlite: ttyS0 at MMIO 0x10000c00 (irq = 20, base_baud = 2500000) is a Palmchip BK-3103
[    0.550272] console [ttyS0] enabled
[    0.550272] console [ttyS0] enabled
[    0.564087] bootconsole [early0] disabled
[    0.564087] bootconsole [early0] disabled
[    0.585731] spi spi0.0: force spi mode3
[    0.594232] m25p80 spi0.0: mx25l3205d (4096 Kbytes)
[    0.604055] 5 fixed-partitions partitions found on MTD device spi0.0
[    0.616719] Creating 5 MTD partitions on "spi0.0":
[    0.626282] 0x000000000000-0x000000020000 : "u-boot"
[    0.637207] 0x000000020000-0x0000003c0000 : "firmware"
[    0.650124] 2 uimage-fw partitions found on MTD device firmware
[    0.661984] Creating 2 MTD partitions on "firmware":
[    0.671894] 0x000000000000-0x00000019a000 : "kernel"
[    0.682709] 0x00000019a000-0x0000003a0000 : "rootfs"
[    0.693456] mtd: device 3 (rootfs) set to be root filesystem
[    0.706437] 1 squashfs-split partitions found on MTD device rootfs
[    0.718827] 0x000000390000-0x0000003a0000 : "rootfs_data"
[    0.730527] 0x0000003c0000-0x0000003e0000 : "reserved"
[    0.741673] 0x0000003e0000-0x0000003f0000 : "nvram"
[    0.752316] 0x0000003f0000-0x000000400000 : "factory"
[    0.764112] libphy: Fixed MDIO Bus: probed
[    0.783591] gsw: setting port4 to ephy mode
[    0.792003] mtk_soc_eth 10100000.ethernet eth0 (uninitialized): port 3 link up (100Mbps/Full duplex)
[    0.810577] mtk_soc_eth 10100000.ethernet: loaded mt7620 driver
[    0.823104] mtk_soc_eth 10100000.ethernet eth0: mediatek frame engine at 0xb0100000, irq 5
[    0.840118] rt2880_wdt 10000120.watchdog: Initialized
[    0.851620] NET: Registered protocol family 10
[    0.864557] Segment Routing with IPv6
[    0.872037] NET: Registered protocol family 17
[    0.880975] 8021q: 802.1Q VLAN Support v1.8
[    0.904192] VFS: Mounted root (squashfs filesystem) readonly on device 31:3.
[    0.924738] Freeing unused kernel memory: 1192K
[    0.933798] This architecture does not have kernel memory protection.
[    2.451025] init: Console is alive
[    2.458129] init: - watchdog -
[    2.556853] random: fast init done
[    4.089243] kmodloader: loading kernel modules from /etc/modules-boot.d/*
[    4.359941] kmodloader: done loading kernel modules from /etc/modules-boot.d/*
[    4.376285] init: - preinit -
[    5.912596] random: jshn: uninitialized urandom read (4 bytes read)
[    6.013097] random: jshn: uninitialized urandom read (4 bytes read)
[    6.351560] random: jshn: uninitialized urandom read (4 bytes read)
[    7.252972] 8021q: adding VLAN 0 to HW filter on device eth0
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug[    7.334625] urandom_read: 4 callbacks suppressed
 level
[    7.334633] random: procd: uninitialized urandom read (4 bytes read)
[    8.018279] mount_root: jffs2 not ready yet, using temporary tmpfs overlay
[    8.058707] urandom-seed: Seed file not found (/etc/urandom.seed)
[    8.190220] procd: - early -
[    8.196073] procd: - watchdog -
[    8.402215] procd: - watchdog -
[    8.408862] procd: - ubus -
[    8.443943] random: ubusd: uninitialized urandom read (4 bytes read)
[    8.458662] random: ubusd: uninitialized urandom read (4 bytes read)
[    8.473173] procd: - init -
Please press Enter to activate this console.
[    9.251810] kmodloader: loading kernel modules from /etc/modules.d/*
[    9.283262] ip6_tables: (C) 2000-2006 Netfilter Core Team
[    9.321622] Loading modules backported from Linux version v5.7-rc3-0-g6a8b55ed4056
[    9.336784] Backport generated by backports.git v5.7-rc3-1-0-gc0c7d2bb
[    9.384501] ip_tables: (C) 2000-2006 Netfilter Core Team
[    9.420241] nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
[    9.559137] xt_time: kernel timezone is -0000
[    9.687704] PPP generic driver version 2.4.2
[    9.712784] NET: Registered protocol family 24
[    9.778353] rt2800_wmac 10180000.wmac: loaded eeprom from mtd device "factory"
[    9.792824] ieee80211 phy0: rt2x00_set_rt: Info - RT chipset 6352, rev 0500 detected
[    9.808276] ieee80211 phy0: rt2x00_set_rf: Info - RF chipset 7620 detected
[    9.951974] kmodloader: done loading kernel modules from /etc/modules.d/*
[    9.994390] urngd: jent-rng init failed, err: 2