Silence silence48

## qakcd4.ender_6_bigtreetech_octopus_klipper_config
Following on from my post about my BTT SKR 2 and Klipper config, I present to you my BTT Octopus + Klipper config for my Ender 6.

I upgraded from the SKR 2 to Octopus because my SKR 2 was one of the first batch with the defect, and I aso liked the additional connections available on the Octopus.

# This file contains common pin mappings for the BigTreeTech Octopus V1 + Ender 6.
# To use this config, the firmware should be compiled for the
# STM32F446 with a "32KiB bootloader".
# Enable "extra low-level configuration options" and select the "12MHz crystal"
# as clock reference.

## keybase.md

      
        
          
            
              
              1 file
            
          
          
            
              
              0 forks
            
          
          
            
              
              0 comments
            
          
          
            
              
              0 stars
            
          
        
        
          
              
          
          
            
                silence48
                / keybase.md
            
            
              Created
              December 20, 2020 22:16
            
          
        
      
        
  
      
    Keybase proof

I hereby claim:

I am silence48 on github.
I am silence48 (https://keybase.io/silence48) on keybase.
I have a public key ASBefeTYEaLKHqhJf5v76nXdKU07FC-6FZBu8AGpgDwKUQo

To claim this, I am signing this object:
	Following on from my post about my BTT SKR 2 and Klipper config, I present to you my BTT Octopus + Klipper config for my Ender 6.

	I upgraded from the SKR 2 to Octopus because my SKR 2 was one of the first batch with the defect, and I aso liked the additional connections available on the Octopus.

	# This file contains common pin mappings for the BigTreeTech Octopus V1 + Ender 6.
	# To use this config, the firmware should be compiled for the
	# STM32F446 with a "32KiB bootloader".
	# Enable "extra low-level configuration options" and select the "12MHz crystal"
	# as clock reference.