- Start at default curve.
- Ctrl-click-drag any point in right-half to bend it until a point intersects with desired mhz/voltage.
- Select point and adjust to perfection using shift-up-down.
- Shift-click-drag empty space and select points (including selected point) on the right. Selected point should be left-most point.
- Shift-Enter twice to flatten all points in selection area. They will flatten to match the selected point.
- Adjust if required.
-
Tab - Next point
-
Shift-Tab - Previous point
-
Shift-Up/Down - Move point up/down (rounds to nearest 5 when applied)
-
Enter - Text enter mode
-
Shift-Enter - Switch to mhz mode
-
Shift-Enter (x2) - Flatten selected range to selected point
-
Shift-click-drag in space - select range
- Up/down arrow to move all selected. (Selected point must be in range)
-
Shift-click-drag point - Move all points up/down
-
Ctrl-click-drag point - Rotate curve
- Dragging point situated in the left/right half of graph decides the pivot point (left-most or right-most point).
-
Ctrl-z - Undo
-
Ctrl-y - Redo
I wish I knew where the file was as the graph is a huge pita and refuse to accept what I do. I see it in the graph then click the check mark and it always bounces back, or other weirdness.