makehub

#Here's an awesome Robot project

### duration project: 2h

Materials list
 1.  Arduino uno
 2. light sensor
 3.  cardboard

##how to
1. Step 1
![alt text](http://www.slipperybrick.com/wp-content/uploads/2009/08/little_ken.jpg "Overview Robot")

2. Step 2
<br>
<b>Markdown works *fine* in here.</b>

3. Step3 Arduino code
<br>
<!-- language: arduino# -->


void setup()
  {
    Serial.begin(9600);            //start the serial monitor with 9600 baud
    pinMode(13, OUTPUT);     //we mostly use13 because there is already a built in yellow LED in arduino which shows output when 13 pin is enabled
  }
 
void loop()
  {
    LDRValue = analogRead(LDR);          //reads the ldr’s value through LDR which we have set to Analog input 0 “A0″
    Serial.println(LDRValue);                  //prints the LDR values to serial monitor
    delay(50);                                                //This is the speed by which LDR sends value to arduino
 
    if (LDRValue < light_sensitivity) 
      {
        digitalWrite(13, HIGH);
      }
    else
      {
        digitalWrite(13, LOW);
      }
  }