Rapiro BLE Nano

arduino_ble_service_setup.ino

// The Nordic UART Service
static const uint8_t uart_base_uuid[] = {0x71, 0x3D, 0, 0, 0x50, 0x3E, 0x4C, 0x75, 0xBA, 0x94, 0x31, 0x48, 0xF1, 0x8D, 0x94, 0x1E};
static const uint8_t uart_tx_uuid[]   = {0x71, 0x3D, 0, 3, 0x50, 0x3E, 0x4C, 0x75, 0xBA, 0x94, 0x31, 0x48, 0xF1, 0x8D, 0x94, 0x1E};
static const uint8_t uart_rx_uuid[]   = {0x71, 0x3D, 0, 2, 0x50, 0x3E, 0x4C, 0x75, 0xBA, 0x94, 0x31, 0x48, 0xF1, 0x8D, 0x94, 0x1E};
static const uint8_t uart_base_uuid_rev[] = {0x1E, 0x94, 0x8D, 0xF1, 0x48, 0x31, 0x94, 0xBA, 0x75, 0x4C, 0x3E, 0x50, 0, 0, 0x3D, 0x71};

uint8_t txPayload[TXRX_BUF_LEN] = {0,};
uint8_t rxPayload[TXRX_BUF_LEN] = {0,};

GattCharacteristic  txCharacteristic (uart_tx_uuid, txPayload, 1, TXRX_BUF_LEN,
                                      GattCharacteristic::BLE_GATT_CHAR_PROPERTIES_WRITE | GattCharacteristic::BLE_GATT_CHAR_PROPERTIES_WRITE_WITHOUT_RESPONSE);
                                      
GattCharacteristic  rxCharacteristic (uart_rx_uuid, rxPayload, 1, TXRX_BUF_LEN,
                                      GattCharacteristic::BLE_GATT_CHAR_PROPERTIES_NOTIFY);
                                      
GattCharacteristic *uartChars[] = {&txCharacteristic, &rxCharacteristic};

GattService         uartService(uart_base_uuid, uartChars, sizeof(uartChars) / sizeof(GattCharacteristic *));

event.ino

void onDataWritten(uint16_t charHandle)
{	
    uint8_t buf[TXRX_BUF_LEN];
    uint16_t bytesRead;
	
    if (charHandle == txCharacteristic.getHandle()) 
    {
        ble.readCharacteristicValue(txCharacteristic.getHandle(), buf, &bytesRead);
        for(uint8_t i=0; i<bytesRead; i++)
        {
            Serial.write(buf[i]);
        }
    }
}