jan53n

######################
# - Conky settings - #
######################
update_interval 1
total_run_times 0
net_avg_samples 1
cpu_avg_samples 1
if_up_strictness link

gbaman

Raspberry Pi Zero OTG Mode

Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).

The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int

miguelmota

How to set up multiple accounts with Mutt E-mail Client

Thanks to this article by Christoph Berg

Instructions

Directories and files

~/

Master chip

/*
 *************************** Brick Cellphone with Sim900 **********************************************
                             Motorola, Ultra Sleek 9660
                             
            Code for replacement motherboard for Motorola, Ultra Sleek 9660,
                   using ATmega328p and Adafruit 128x32 OLED Screen 
                             
                                Created 19 October 2012
                               by Andrew D. Farquharson
                               

scottburton11

About compression

Audio compression is used to reduce the dynamic range of a recording. Dynamic range is the difference between the loudest and softest parts of an audio signal. It was originally used to guard against defects when cutting wax and vinyl phonograph records, but generally became useful as a way of increasing the loudness of an audio recording without achieving distortion.

The goal of most compression applications is to increase the amplitude of the softest parts of a recording, without increasing the amplitude of the loudest parts.

Compressor anatomy

Compressors generally all have the same conceptual parts. However, not all compressors present variable controls for all parts to the user. If you don't see all of your compressor's controls here, there's a chance it either has a fixed value (and no control), or is named something else: