Skip to content

Instantly share code, notes, and snippets.

View woojak's full-sized avatar

Mateusz woojak

0 followers · 1 following
View GitHub Profile
@woojak
woojak / config
Created September 8, 2016 03:27
/*
This file is part of Repetier-Firmware.
Repetier-Firmware is free software: you can redistribute it and/or modify
it under the terms of the GNU General Public License as published by
the Free Software Foundation, either version 3 of the License, or
(at your option) any later version.
Repetier-Firmware is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
@woojak
woojak / config
Created September 6, 2016 13:51
/*
This file is part of Repetier-Firmware.
Repetier-Firmware is free software: you can redistribute it and/or modify
it under the terms of the GNU General Public License as published by
the Free Software Foundation, either version 3 of the License, or
(at your option) any later version.
Repetier-Firmware is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
@woojak
woojak / Kostka
Created September 6, 2016 12:01
This file has been truncated, but you can view the full file.
; generated by Slic3r 1.2.9 on 2016-09-06 at 13:45:37
; external perimeters extrusion width = 0.40mm
; perimeters extrusion width = 0.48mm
; infill extrusion width = 0.48mm
; solid infill extrusion width = 0.48mm
; top infill extrusion width = 0.48mm
M107
M190 S70 ; set bed temperature