at commands arduino

// this sketch is used for testing LoNet with Arduino 

// Connect VIO to +5V
// Connect GND to Ground
// Connect RX (data into SIM808) to Digital 11
// Connect TX (data out from SIM808) to Digital 10

#include <SoftwareSerial.h>

SoftwareSerial mySerial(2, 3); // RX, TX

void setup()  
{
  // Open serial communications and wait for port to open:
  Serial.begin(9600);
  mySerial.begin(9600);
}

void loop() // run over and over
{
  if (mySerial.available())
    Serial.write(mySerial.read());
    
  if (Serial.available())
  { 
    while(Serial.available())
    {
      mySerial.write(Serial.read());
    }
    mySerial.println();
  }
}