This is a collection of independant scripts to show how to communicate with the QooCam EGO remotely.
They were tested with firmware 2.1.29 in the camera.
They are quite minimal so that you can inpire yourself to create your own awesome utility.
You can also use them directly as is.
It looks like it failed on a large file.
By reading the doc again, I saw that the lib that was called is "normally not used directly".
So I rewrote the whole scripts with a better suited library.
However, the first test I did after the change also failed (OK on small image, KO on 1min video)
Trying alternative methods based on utilities coded by good programmers had the same behavior.
Then I noticed that the firmware looked crashed on the device (there was only camera feedback on the screen, no icons or reaction on buttons)
After reboot, all other tries (10) were successful.
So my guess is that the firmware of the QooCam EGO is buggy on this feature.
Unfortunately, it seems that I cannot do more on my side.