| // ==UserScript== | |
| // @name Remove Facebook Ads | |
| // @version 1.0 | |
| // @description Removes sponsored content from the Facebook news feed. | |
| // @author theftprevention | |
| // @match https://www.facebook.com/ | |
| // @grant none | |
| // ==/UserScript== | |
| (function() { |
sed -E -f solver.sed input where input is a file containing the maze.
For best results, resize your terminal to match the height of the maze. To disable animations, delete the lines containing p.
The solver assumes the following:
# \nSES) and end (E)
Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).
The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int
(by @andrestaltz)
If you prefer to watch video tutorials with live-coding, then check out this series I recorded with the same contents as in this article: Egghead.io - Introduction to Reactive Programming.