Skip to content

Instantly share code, notes, and snippets.

View MichaelNewham's full-sized avatar

Michael Newham MichaelNewham

  • Birr, Offaly, Ireland
  • 12:33 (UTC +01:00)
View GitHub Profile
@MichaelNewham
MichaelNewham / network-manager-raspbian-2020-02-05.md
Created December 9, 2020 15:55 — forked from jjsanderson/network-manager-raspbian-2020-02-05.md
Installing Network Manager on Raspbian 2020-02-05

Installing Network Manager on Raspbian 2020-02-05

Default Raspbian is not able to connect to wifi networks using corporate security setups, including eduroam. However, the issue is that the packaged networking control widget does not expose the relevant security features, rather than any underlying hardware limitation. The solution has long been to install Network Manager and configure it to handle the wifi interface.

Unfortunately, previous installation approaches didn't work for me on the Raspbian 2020-02-06 image. Following a fresh install, the below is what I did to make it work. Note that this is actually simpler than previous recipes.

Install packages

sudo apt update
sudo apt install network-manager network-manager-gnome
@MichaelNewham
MichaelNewham / tronxy-pla-s3d.txt
Created June 8, 2020 00:42 — forked from nonsintetic/tronxy-pla-s3d.txt
TronXY X1 - Simplify3D generic settings for PLA
Extruder:
- Nozzle Diameter: 0.40mm
- Extrusion Multiplier: 1.00 (can fiddle with this: if you get holes in top layers - increase, if you get blobs and the head digs into the current layer - decrease)
- Extrusion Width: auto
- Retraction:
- Distance: 4-6mm or less even
- Extra Restart Dist: 0.5
- Vertical Lift: 0
- Retraction Speed: 3000
- Coast at end - enabled - 0.1mm
@MichaelNewham
MichaelNewham / tronxy-pla-s3d.txt
Created June 8, 2020 00:42 — forked from nonsintetic/tronxy-pla-s3d.txt
TronXY X1 - Simplify3D generic settings for PLA
Extruder:
- Nozzle Diameter: 0.40mm
- Extrusion Multiplier: 1.00 (can fiddle with this: if you get holes in top layers - increase, if you get blobs and the head digs into the current layer - decrease)
- Extrusion Width: auto
- Retraction:
- Distance: 4-6mm or less even
- Extra Restart Dist: 0.5
- Vertical Lift: 0
- Retraction Speed: 3000
- Coast at end - enabled - 0.1mm