A remix of Dataman's toolbelt shelf for the Printrbot play

PrintrbotPlayToolbelt.scad

// PrintrBot Play ToolBelt
// 12/6/2016 Dataman, me@crjones.com
// Rev 1.7

$fn=32;

union() {

radius = 5;

// Support angles
translate([1,1,1]) 
    rotate([90,0,0])
    linear_extrude(1) polygon([[0,0], [0,10-radius-1], [10-radius-1,0]]);

translate([1,60,1]) 
    rotate([90,0,0])
    linear_extrude(1) polygon([[0,0], [0,10-radius-1], [10-radius-1,0]]);

// backsplash
difference() {
    // back splash
    difference() {
        cube([1,60,10]);   

        // top-left curve
        translate([0,radius,10-radius])
            rotate([0,90,0])
            difference() {
                translate([-10,-10,-5]) cube([10,10,10]);
                translate([0,0,-5]) cylinder(h=10, r=radius);
            }
    }
    // left screw    
    translate([0,17.75,5.6]) {rotate([0,90,0]) {cylinder(h=5, r=1.75);}}
    // right screw
    translate([0,51,6]) {rotate([0,90,0]) {cylinder(h=5, r=1.75);}}
}

//body
difference(){
 // body   
 cube([26,60,1]);
 //tweezers
 translate([8,2,0]) {cube([14,4,1]);}
 //s nips
 translate([4,10,0]) {cube([8,14,1]);}
 // hex 1
 translate([17.5,10,0]) {cylinder(h=1, r=2);}
 // hex 2
 translate([17.5,16,0]) {cylinder(h=1, r=1.75);}
 // hex 3
 translate([17.5,21.5,0]) {cylinder(h=1, r=1.5);}
  // screwdriver 1
 translate([18.5,30.5,0]) {cylinder(h=1, r=3.5);}
 // alignment device
 translate([2,38,0]) {cube([22,1.75,1]);}
 //wrench 1
 translate([3,41,0]) {cube([21,7,1]);}
 //wrench 2
 translate([3,50,0]) {cube([21,7,1]);}
 }
 
 // hex nubs
 translate([20,7,1]) {cube([3,2,1]);}
 translate([20,12,1]) {cube([3,3,1]);}
 translate([20,17.5,1]) {cube([3,3,1]);}
 translate([20,22,1]) {cube([3,2,1]);}
 
 }