| :020000040000FA | |
| :0600000014EF18F01200DD | |
| :0600080004EF08F01200F5 | |
| :060018000CEF08F01200DD | |
| :0608000014EF18F01200D5 | |
| :060808000FEF08F01200E2 | |
| :0608180012EF08F01200CF | |
| :0610000014EF18F01200CD | |
| :021006000000E8 | |
| :061008000FEF08F01200DA |
Following commands create a shared system-wide install in /opt/q13
The last version that supports MAX7000 (and thus ATF15xx) is 13.0sp1
https://www.intel.com/content/www/us/en/software-kit/711790/intel-quartus-ii-web-edition-design-software-version-13-0sp1-for-linux.html
The variables $Q and $M will be set at the top here but used throughout,
so only paste these commands in the same session where Q and M are set!
| Location of the zip with the quartus project, scans and this note: | |
| https://drive.google.com/file/d/19l7rQpiQJmDnbOJQavnp8BZulNxUG0uI/view?usp=sharing | |
| Power | |
| I injected 5V on C60 (Fat ceramic cap , on top lower right corner near the sodimm edge) | |
| The Module needs a fair ammount of current to start up properly. I had my lab supply at 3A current | |
| limit, with the original config bitstream off the config prom on the module it draws about 700mA after startup |