2023-05-02 - Since a few days ago \colorbox and \fcolorbox are broken and Github did't talk about if it's a temporary thing or if it will not be added back.
As you can se with the above message(s) Tex may not be very stable and may not be an option to you as of the dates expressed above. You can also check other tex problems here.
When using the TMC2130 / TMC2209 / TMC2660 / TMC5160 drivers, the StallGuard feature makes it possible to set up sensorless homing on the X and Y axes for CoreXY machines. The Klipper project has a page with documentation and recommendations on getting it working.
Following are some more detailed instructions and suggestions to supplement the Klipper documentation specifically for Vorons.
| # This file contains pin mappings for the Anycubic i3 Mega with | |
| # Ultrabase from 2017. (This config may work on an Anycubic i3 Mega v1 | |
| # prior to the Ultrabase if you comment out the definition of the | |
| # endstop_pin in the stepper_z1 section.) To use this config, the | |
| # firmware should be compiled for the AVR atmega2560. | |
| # See the example.cfg file for a description of available parameters. | |
| [stepper_x] | |
| step_pin: PF0 |
