Skip to content

Instantly share code, notes, and snippets.

Embed
What would you like to do?
Raspberry Pi 3 access-point-setup
#!/bin/bash
#
# This version uses September 2017 august stretch image, please use this image
#
if [ "$EUID" -ne 0 ]
then echo "Must be root"
exit
fi
if [[ $# -lt 1 ]];
then echo "You need to pass a password!"
echo "Usage:"
echo "sudo $0 yourChosenPassword [apName]"
exit
fi
APPASS="$1"
APSSID="rPi3"
if [[ $# -eq 2 ]]; then
APSSID=$2
fi
apt-get remove --purge hostapd -yqq
apt-get update -yqq
apt-get upgrade -yqq
apt-get install hostapd dnsmasq -yqq
cat > /etc/dnsmasq.conf <<EOF
interface=wlan0
dhcp-range=10.0.0.2,10.0.0.5,255.255.255.0,12h
EOF
cat > /etc/hostapd/hostapd.conf <<EOF
interface=wlan0
hw_mode=g
channel=10
auth_algs=1
wpa=2
wpa_key_mgmt=WPA-PSK
wpa_pairwise=CCMP
rsn_pairwise=CCMP
wpa_passphrase=$APPASS
ssid=$APSSID
ieee80211n=1
wmm_enabled=1
ht_capab=[HT40][SHORT-GI-20][DSSS_CCK-40]
EOF
sed -i -- 's/allow-hotplug wlan0//g' /etc/network/interfaces
sed -i -- 's/iface wlan0 inet manual//g' /etc/network/interfaces
sed -i -- 's/ wpa-conf \/etc\/wpa_supplicant\/wpa_supplicant.conf//g' /etc/network/interfaces
sed -i -- 's/#DAEMON_CONF=""/DAEMON_CONF="\/etc\/hostapd\/hostapd.conf"/g' /etc/default/hostapd
cat >> /etc/network/interfaces <<EOF
# Added by rPi Access Point Setup
allow-hotplug wlan0
iface wlan0 inet static
address 10.0.0.1
netmask 255.255.255.0
network 10.0.0.0
broadcast 10.0.0.255
EOF
echo "denyinterfaces wlan0" >> /etc/dhcpcd.conf
systemctl enable hostapd
systemctl enable dnsmasq
sudo service hostapd start
sudo service dnsmasq start
echo "All done! Please reboot"
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
You can’t perform that action at this time.