Sometimes a PSSE won't open after install. This is almost always caused by an unexpected Python configuration.
If you're struggling with MOD, see the MOD Debug Notes
Behavior:
Test-Connection 8.8.8.8 -Delay 30 -Count ([int32]::MaxValue) | format-table @{n='TimeStamp';e={Get-Date}},Ping, Source, Address, Latency, Status | Out-File ping.txt |
<div id="app"> | |
<v-app> | |
<v-main> | |
<v-container fluid> | |
<v-row> | |
<v-col cols=12> | |
<v-card class="mb-4"> | |
<v-card-title> | |
Tower Config | |
</v-card-title> |
Sometimes a PSSE won't open after install. This is almost always caused by an unexpected Python configuration.
If you're struggling with MOD, see the MOD Debug Notes
Behavior:
MOD File Builder often has trouble connecting to the PSSE API if the environment on your machine isn't exactly like PSSE/MOD expects.
This document show some common issues with MOD File Builder install and how to fix them.
If you can't get PSSE to open without MOD, you need to debug that first. Here are some PSSE Debug Notes
// Generate a Sankey diagram from a savnw case solve. | |
// Values are entered by hand, so probably not accurate. | |
// Loads are not shown so it looks like Kirchoff is violated | |
// https://sankeymatic.com/build/ | |
// | |
// Enter Flows between Nodes, like this: | |
// Source [AMOUNT] Target | |
MINE G [260] MINE | |
HYDRO G [600] HYDRO |
******************* | |
Selected Line Name: Tower 1; Circuit 1 | |
******************* | |
As an aid in setting distance relays, the worst case positive | |
sequence line impedance, assuming untransposed phases, is: | |
0.0357 +j 0.1484 Ohms, or 0.1527 Ohms @ 76.47 degrees. | |
A zone 1 reach set to this value will not overreach the line. | |
Length: 0.41 miles | |
Surge impedance: 192.80 ohms Loading: 98.777 MW |
******************* | |
Selected Line Name: Tower 1; Circuit 1 | |
******************* | |
As an aid in setting distance relays, the worst case positive | |
sequence line impedance, assuming untransposed phases, is: | |
0.0357 +j 0.1484 Ohms, or 0.1527 Ohms @ 76.47 degrees. | |
A zone 1 reach set to this value will not overreach the line. | |
Length: 0.41 miles |
// Bot to copy messages which match a pattern from one channel to another | |
// edit the vars below | |
var SOURCE_CHANNEL = '830874514241749013'; // #rconlog | |
var DEST_CHANNEL = '804394923947851796'; // #The-Gulag | |
var PATTERN1 = 'do_punish'; | |
var PATTERN2 = 'do_kick'; | |
var PATTERN3 = 'do_perma_ban'; | |
var PATTERN4 = 'do_temp_ban'; | |
var PATTERN5 = 'unban'; |