The squares in the chanmon buffer at the top of weechat in the gif above are there only to hide the nicknames and the messages in the gif to respect users privacies
Raspberry Pi Zero OTG Mode
Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).
The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int
Docker - How to cleanup (unused) resources
Once in a while, you may need to cleanup resources (containers, volumes, images, networks) ...
// see: https://github.com/chadoe/docker-cleanup-volumes $ docker volume rm $(docker volume ls -qf dangling=true) $ docker volume ls -qf dangling=true | xargs -r docker volume rm
Here I will show you how to create a bar very similar to the nicklist bar, but instead of showing nickname, it will show znc commands, whenever you click on a command, weechat will send a "help the_command_you_just_clicked" and insert the name of the command in the input bar, then enter any arguments required to the command and press enter.
You will need the following script