gbaman

Raspberry Pi Zero OTG Mode

Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).

The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int

untrusted-lvl13-solution.js

/*
 * robotMaze.js
 *
 * The blue key is inside a labyrinth, and extracting
 * it will not be easy.
 *
 * It's a good thing that you're a AI expert, or
 * we would have to leave empty-handed.
 */

aras-p

// Just before switching jobs:
// Add one of these.
// Preferably into the same commit where you do a large merge.
//
// This started as a tweet with a joke of "C++ pro-tip: #define private public",
// and then it quickly escalated into more and more evil suggestions.
// I've tried to capture interesting suggestions here.
//
// Contributors: @r2d2rigo, @joeldevahl, @msinilo, @_Humus_,
// @YuriyODonnell, @rygorous, @cmuratori, @mike_acton, @grumpygiant,