-
-
Save jeje/3027236 to your computer and use it in GitHub Desktop.
#include <IRremote.h> | |
int RECV_PIN = 11; | |
IRrecv irrecv(RECV_PIN); | |
IRsend irsend; | |
boolean recording = true; | |
decode_results results; | |
void setup() | |
{ | |
Serial.begin(9600); | |
irrecv.enableIRIn(); // Start the receiver | |
} | |
void loop() { | |
if (recording) { | |
if (irrecv.decode(&results)) { | |
Serial.println("IR code recorded!"); | |
//irrecv.resume(); // Receive the next value | |
Serial.print("Recorded "); | |
Serial.print(results.rawlen); | |
Serial.println(" intervals."); | |
recording = false; | |
} | |
} else { | |
// replay mode | |
Serial.println("Sending recorded IR signal!"); | |
irsend.sendRaw((unsigned int*) results.rawbuf, results.rawlen, 38); | |
delay(2000); | |
} | |
} |
For those who are able to receive and not send, though this might be obvious, check if you have an IR transmitter sensor module/support. If it's only an IR receiver sensor module you have, sending the IR codes back on a certain pin, after receiving will be just of no use! I am saying this from my earlier experience when I started playing with them! :) Cheers.
@RaghavanSanthanam could you pls mention the pin mapping for the ir send code
hello everyone, iam doing a project i.e using ir remote codes to control the consumer products using arduino, ir receiver and ir led. i controlled the NEC protocol products but i didn't control the SAMSUNG protocol devices .i want control the LLOYD AC .it has SAMSUNG protocol .can you please help me.
thank you.
It is recieving and sending but it don't switch my Panasonic tv.
send pin ??!!
send pin is pin3 un uno328
It's receiving but not sending - (I use a couple of transistors, because I have a lot of IR LED's in my project)