Skip to content

Instantly share code, notes, and snippets.

@lolstone
lolstone / Klipper Anycubic i3 Mega
Created April 25, 2024 18:34 — forked from bistory/Klipper Anycubic i3 Mega
Anycubic i3 Mega configuration for Klipper (with TMC2209 + SPI, BMG extruder with stock motor, pressure advance and BLTouch clone)
# This file contains pin mappings for the Anycubic i3 Mega with
# Ultrabase from 2017. (This config may work on an Anycubic i3 Mega v1
# prior to the Ultrabase if you comment out the definition of the
# endstop_pin in the stepper_z1 section.) To use this config, the
# firmware should be compiled for the AVR atmega2560.
# See the example.cfg file for a description of available parameters.
[stepper_x]
step_pin: PF0