gbaman

Raspberry Pi Zero OTG Mode

Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).

The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int

atcuno

The purpose of this document is to make recommendations on how to browse in a privacy and security conscious manner. This information is compiled from a number of sources, which are referenced throughout the document, as well as my own experiences with the described technologies.

I welcome contributions and comments on the information contained. Please see the How to Contribute section for information on contributing your own knowledge.

Table of Contents

• Motivation
• Audience
• TL;DR?
• Updates
• Technologies that Affect Security and Privacy

staltz

The introduction to Reactive Programming you've been missing

(by @andrestaltz)

---

This tutorial as a series of videos

If you prefer to watch video tutorials with live-coding, then check out this series I recorded with the same contents as in this article: Egghead.io - Introduction to Reactive Programming.

---

chrisbanes

/*
 * Copyright 2014 Chris Banes
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *    http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software

plentz

# to generate your dhparam.pem file, run in the terminal
openssl dhparam -out /etc/nginx/ssl/dhparam.pem 2048